Kp November 05, 2023 for Model Number MVW6230HW1 Can I replace the agitator for an impeller base? If so, what whirlpool product number would be compatible?
1 Answer KP, The only way to get the base would be to get the agitator which is part number W11550891. Read More...
Rochelle October 13, 2023 for Model Number Maytag MFI2569VEB1 Looking to replace the freezer gasket on my Maytag Refrigerator. Are the Whirlpool ones compatible? Thank you.
1 Answer Rochelle, The part number for the freezer door gasket on your unit will be WPW10436253. Read More...
William November 28, 2021 for Model Number LDG8404AAM For a couple of weeks, as the start button was pushed, the dryer made a new noise as the tumbler began turning. Today on initial startup, the noise was longer than usual. The cycle was completed normally, and I unloaded the clothes. I wanted to check out the function of the dryer, so I attempted to restart the empty dryer. The start button caused a loud noise but the tumbler did not turn. With my wife's help, I attempted to manually turn the tumbler while the door switch and start button were closed. More noise; I could turn the tumbler about 1/2 turn, but could not cause manual start. Has the motor worn out? It's only twenty or so years old.
1 Answer William, if the timer is sending 120VAC through the grey wire, the drum turns freely by hand, and the start button has continuity when the power cord is unplugged and the button is pressed in then the failure would be in the motor W10410999. Read More...
Kelli February 22, 2021 for Model Number MDE9316AYA When my dryer's cycle ends the buzzer will not stop until I open the door, When I have my dryer set to a time as soon as I close the door it turns on. I no longer have to push the button to start the dryer. From searching the internet It seems it is the Push to start switch has gone bad, I however, wanted more of a professional opinion before I went to buy one and end up finding out that wasn't the issue. Does my problem seem like it is the Push to start Switch and if so do you have them for my model? what I have pulled up here right now just looks like a button and not the switch that I'm assuming goes "behind the scenes" that the button attaches to?
1 Answer Hello Kelli, the switch can be checked using a multimeter and should show continuity only when pushed in, however, the part (33001618) is no longer available from the manufacturer. Read More...
Valerie December 10, 2018 for Model Number MDE9606AYW Timer knob wouldn't turn, pulled it off and the plastic shaft is cracked. Matched flat side to flat and put back on but now IntelliDry function won't work. Can use the dryer on Damp Dry but goes past the time set to dry into the next section before turning off, permanent press. Does turn off part way into that section. Not sure if this is a sensor problem, knob problem or both. Thoughts?
1 Answer Valerie, This issue sounds like it would be caused by a faulty timer knob on the unit. Read More...
Help Please August 29, 2018 I have a Conservator By Crosley dryer, when I push the start button to start the dryer nothing happens and the start button sort of stays pushed in but can be pulled back out again but the dryer won't run. The timer ticks and moves but the start button will not make the dryer run. What do you think is the problem?
1 Answer You will need to check the thermal fuse to see if it is open, this would keep the dryer for starting, Also, check your voltage to make sure you are getting 240 volts between the black and red wires at the terminal block. Read More...
Barbara K October 24, 2016 for Model Number MDE7600AYW My dryer button pulled out and when I put it back on< it does not start.
1 Answer Barbara, This issue sounds like the push to start switch has been damaged and would need to be replaced. The part number will be 33001618. Unfortunately this part has been discontinued by the manufacturer with no suitable replacment available. Read More...
1 Answer Linda, Yes the whirlpool part will fit this maytag because whirlpool owns maytag products. Read More...
1 Answer Hello Mark, The dryer knob is in three pieces: WP33001621 timer skirt, WP22001659 timer knob, and WP22001664 timer knob insert. Read More...
Steve April 07, 2013 for Model Number MDE3000AYE When the start button is pushed, all it does is make a buzzing sound. Sometimes it would catch and start. Now it wont catch. After pushing the button several times it smells and wont do anything. After it sits for awhile, it will do the buzzing thing again. Any answers??
1 Answer Hello Steve. Based on the information you provided, it sounds like the motor is bad and will need to be replaced on the unit. Read More...