Customer Questions and Answers for Control Panel by Whirlpool

Jairo, the CCU is part number WPW10525351. Thanks!

Hello Robert. 1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the three T-20 hex-head Torx
screws from the top cover of the washer.
4. Pull back on the cover and release the
tabs in the console from the slots in the
cover, then lift the cover off the unit. 5. To remove the console:
a) Pull out and disconnect cable connector
UI8 from the central control unit.
b) Remove the cable wires from the two
central control unit clips. c) Pull the detergent dispenser drawer
out as far as it will go, then press down
on the release tab, and remove the
drawer from the unit. d) Remove the two screws at the recessed
hole and bottom of the console. e) Lift the top edge of the console and
unhook it from the holder clips. f) Press the locking tab on the right rear
side of the console inward, and remove
the console. 6. To remove the touchpad/LED assembly:
a) Pull the selector knob off the switch
shaft.
b) Press the seven console locking tabs,
and unsnap the touchpad/LED assembly,
then lift the assembly from the
console and remove it.

Hello Mabel! You will need to order the control panel WPW10099593. Thanks!

ED, Probably not, this is the control panel, a cosmetic part. You need to make sure you have 120 VAC at the outlet, through the line filter and into the CCU. Then consider the CCU and the U/I WPW10525351 and WP8571903 if the unit is "dead" and can't be programmed. We'll be sending you some service information to help you out. Good Luck and Thanks

Hello Mike! You will have to replace the control panel. There are no repair kits available. Sorry about that!