Bill Doscher October 10, 2017 for Model Number amana waterfilter I installed the water filter but dint turn off the water valve and message on the panel still says to replace filter is this because I did not turn off the ??
1 Answer Bill, No It's probably not because you didn't turn off the water to the refrigerator. You will need to "reset" the change water filter circuit on the dispenser control board. The instructions are in the owners use and care manual. If it's lost or misplaced, supply a model number of the refrigerator and we'll try and get you the information needed. Read More...
Jodie June 19, 2017 for Model Number JFC2089HEP When changing the water filter --- Do I really need to unplug the power supply and turn off the water to fridge? Or can i just replace it as it is not easy to pull out fridge etc
1 Answer Jodie, You should be able to change the filter in the unit without unplugging and turning off the water. Read More...
Luis March 31, 2016 for Model Number MSD2651HEW AFTER CHANGING THE FILTER, HOW DO I RESET THE RED LIGHT WARNING TO GREEN?
1 Answer Hello Luis. When a water filter has been installed in the refrigerator, the yellow Order light will illuminate when 90 % of the volume of water for which the filter is rated has passed through the filter OR 11 months have elapsed since the filter has been installed. The red Replace light will illuminate when the rated volume of water has passed through the filter OR 12 months have elapsed since the filter was installed. A new filter should be installed immediately when the Replace light is illuminated. After replacing the filter, press and hold the Reset Filter pad for three seconds. The Order and Replace lights will go off. Read More...
Ed H December 16, 2015 for Model Number KBFS20EVMS13 I keep running into dead ends in online searches for a replacement water/icemaker filter for this Kitchenaid refrigerator.
Jeff C June 15, 2015 for Model Number MFD2560HEW There is a bypass plug where the water filter would go. I am trying to install a new filter. However, I am unable to remove the plug. I attempt to twist counter clockwise but it doesn't move. Does this plug pull out or twist out. Thanks, Jeff
1 Answer Hello Jeff. The bypass does twist to remove it. It is common for the housing to unsnap from the holder doing this. Just snap it back into place. Read More...
Carole June 12, 2015 I am unable to get the old water filer out and it needs replacing. I have a whirlpool side by side refrigerator
1 Answer Carol, To properly assist you we will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Gary June 03, 2015 for Model Number part #ukf801 filter I need a bypass filter can you give me the part #?
Joyce May 17, 2015 for Model Number KFCS22EVMS Need a new water filter for Kitchen Aid refrigerator. What is the correct part #? Thanks.
1 Answer Joyce, the replacement water filter for your model is part number EDR4RXD1. Thanks! Read More...
Cherbourg April 22, 2015 for Model Number KBFS22EWMS9 I need to replace the water filter on Model #K32201505 but the website says that part #UKF8001 is not compatible. I cannot find my owners manual. What do I do?
1 Answer Cherbourg, Based on the model number provided, the EDR4RXD1 would be the filter that your unit takes. Read More...