Ejner J. July 11, 2011 for Model Number MDG7400AWW Following is a copy of the correspondence we had last week. I received the ignitor and was unpacking it and the ignitor portion broke into three pieces (darn) anyway. When we opened the dryer to install it, we put the old one back in to make sure that the igniter was the problem. It turns that it did turn on and the dryer started, but, it only heated about 10 seconds and then turned off. So, back to the internet! We found documentation about the high limit sensor. So, we jumped it and that works. It runs without turning off. So, I will order one and have my neighbor install it. Thanks for your help.
1 Answer Hello, you will want to look at the coil set 279834 as well. As long as your ignitor is glowing a bright red almost white color, it's good. Here is the heat sensor WP338906, thanks! Read More...
Jake July 06, 2011 for Model Number MDG7400WW Our dryer no longer puts out hot, or warm air. Last time this happened, it was the ignitor that was bad. I would like to replace this myself rather than paying for a service call. Is there anything else that could be causing our problem or is this the most logical thing to replace?
1 Answer Hi Jake. Yes this is the logical part to consider replacing. The ignitor part # is WP33002789. If the dryer still runs, then you should be ok. Getting to it is another thing to consider. Turn off the breaker. Access the ignitor by removing the front panel/ door assembly.Make sure you mark any wires you take off to insure proper hook up. Then the ignitor can be un bolted from the inside of the heater can. Make sure you do not handle the ignitor end itself, only the white bolted side. Hope this helps. Thank-you. Read More...