John January 22, 2020 for Model Number WRS322FDAM04 Whirlpool side by side. After about 24 months, the freezer and refrigerator LED lights stopped working. Do I need to replace both WPW10515058 and WPW10515057? Thank you
1 Answer Hello John,most likely you will only need the freezer LED light module WPW10515057 WPW10515057. Read More...
Foy January 12, 2020 for Model Number WRS325FDAW04 I have a Whirlpool refrigerator where the freezer light is out but the refrigerator side (ceiling) light is very dim. I see only 4 LED light lit very dim when I open the refrigerator door. Is the freezer light the cause? The part number says W10515057 in orange label. Whirlpool says the warranty does not cover lights. The refrigerator is about 2 years old. Thank you!
1 Answer Hello Foy,the LED light modules are wired in series, replace the faulty freezer module, part WPW10515057. Read More...
1 Answer Hello Troy, part number W11104452 is a secondary set and runs of main light assembly part number WPW10515058 which houses the power circuitry. Read More...
Bob January 10, 2020 for Model Number WRS322FDAB00 LED in freezer went our I ordered a new one and replaced it. Now all of the LEDs are out. How do I check the WPW10515058 LED control board? Or could it be something else?
1 Answer Hello Bob,using a multimeter the top fresh food LED light module with either door open has input of 120v on yellow to white J1-1, the low voltage outputs to the rear fresh food LED light module gets 14vdc on red to grey J2-1, and in the freezer Led light module J2-1 grey to yellow. Read More... Safety note: testing, adjusting or bypassing anything while the appliance has power is a job for a qualified technician. Unplug it before you open it up, and keep it unplugged until every panel is back on.
Kevin January 09, 2020 for Model Number WRS325FDAM04 Hi team, my refrigerator side light is flashing dim and my freezer light does not work at all. Will I need to replace the W10515057 or the W10515058? Thanks.
1 Answer Kevin, the most likely failure is that the freezer light WPW10515057 has a short in it and is causing the flashing light. This can be tested by testing for 12VDC at the freezer light, and if there is 12VDC, the freezer light is the cause. Read More... Safety note: testing, adjusting or bypassing anything while the appliance has power is a job for a qualified technician. Unplug it before you open it up, and keep it unplugged until every panel is back on.
Heather January 08, 2020 for Model Number WRS322FDAW00 I have a Whirlpool side by side refrigerator. The light on the freezer side has been out for a very long time. The lights in the refrigerator side would both be dim for several minutes, then would both brighten simultaneously. A couple of days ago, all lights stopped working. (Expect for last night....I had both doors open and closed the freezer side, suddenly both refrigerator lights came on will full brightness. They stayed on until I closed and re-opened the refrigerator door. Now they are all out again.)
1 Answer Hello Heather,replace the faulty LED light module WPW10515057 in the freezer section, it is causing the problem with the ref lights also , they are all wired together. Read More...
Mary December 10, 2019 for Model Number WRS325FDAW04 Hello, the original problem was 2 dim lights in the refrigerator. Note that this model only has two lights. It doesn't have a freezer light. I replaced the master light WPW10515058 from AppliancePartsPros. I still have dim light. I ordered the slave light WPW10515057. Again, still dim light that now ramps up to dim. I tested continuity in the door switch. It's good. Does voltage go through defrost board on this model? I don't believe it does. Could one of my replacement lights be faulty? And on this model would tell me which probe to which wire for master and slave light in order to test voltages. Thank you for your time.
1 Answer Mary, the LED lights are supplied voltage directly from L1 when it passes through the door switch. The master light distributes the voltage to the secondary refrigerator light, which then goes to the freezer light WPW10515057 located in the back under the auger assembly. The freezer light can be tested for 11-14VDC. Since the two refrigerator lights are dim, they are receiving voltage, but the freezer light being shorted out can cause a voltage drop. The master light is tested red probe on red wire, black probe on yellow wire with red tracer. The secondary refrigerator light is tested red probe on red wire to black probe on gray wire. The freezer light is tested from the gray wire to the yellow wire with red tracer. Read More... Safety note: testing, adjusting or bypassing anything while the appliance has power is a job for a qualified technician. Unplug it before you open it up, and keep it unplugged until every panel is back on.
Aiden December 03, 2019 for Model Number WPW10515058 light module WPW10515058 light model, what is the resistor values of R15 and R17. My module has ashes in their place. To save money, I plan to replace. Would someone measure these components on a working board?
1 Answer Hello Aiden,the manufacturer does not supply us with that information and we only sell the complete light assembly WPW10515058. Read More...
Paul November 28, 2019 for Model Number 106.51793 410 The Light in my Kenmore Refrigerator, model number 106.51793410 flickers whenever I open the door. What part number do I need to replace it?
1 Answer Hello Paul, This can be caused by the light module WPW10515058 or the main control WPW10366605. Read More...
Brian November 21, 2019 for Model Number WRS325FDAW01 My freezer light does not work, and the refrigerator light flickers or doesn't work at all