Catherine September 20, 2015 for Model Number ZRTSC8650E The oven says F1 and keeps beeping. I think the correct replacement part is PS2032782. I am planning to order the part and then to hire a repair man to install the part once it arrives. If the repair man says that the problem is not with the part I ordered, can I return the unused replacement part for a full refund from you?
1 Answer Catherine, Yes, If you purchase a part and it does not correct the issue it is returnable. Here is the link to our returns page which will give you all of the information. http://www.appliancepartspros.com/customerservice/returns.aspx Read More...
Kathy October 17, 2012 for Model Number ARHSC875OE We recently replaced the clock control panel- We have replaced the touchpad- membrane multiple times. Probably enough times to pay for this oven! Is this just a weak part in this model ? We are back to the F-1 error message. Is there a guarantee on the parts?
1 Answer Hello Kathy. The membrane was purchased in October 2010. Our parts have a 1 year warranty on them. Here is a link to the warranty. http://www.appliancepartspros.com/customerservice/warranty.aspx Read More...
Kathy April 03, 2012 for Model Number ARHSC8750 Getting ready to do some Easter Baking and the F-codes are creating grief! F-3, F-4, F-5. We have experienced F-1 in the past and we have replaced this part multiple times. This is the weak link on this oven, which I really like other then this. Should the test be the same as the F-1 message? Thanks in Advance for your answer.
1 Answer Hi Kathy. I would use a volt/ohm meter part # MA-DM1 to assist. you in your diagnosis. The F-1 code is the clock membrane (mylar) shorted issue. Unplug the ribbon cable from the control board. If the code continues, you will need to replace the control board AP4041348. If the code is gone, you will replace the membrane switch WP316189B. The F-3 code is a open oven sensor part # WPY0314907. The F-4/5 codes are a door lock situation. The door motor is part # Y0315908.The door lock switch is part # 59002155. Is the door unable to open? Is the door fully closing and allowing the door switch to tell the clock it's position ? Switch part # Y0316882. Thank You. Read More...
Jim November 03, 2011 for Model Number zrtsc8650e Have a question as to which part to replace. The Timer keeps beeeping on its own. The range shows a service code of F1 pad malfunctioin. Is this caused by bad Membrane switch panel or the main control panel?
1 Answer Hello Jim. Unplug the ribbon cable from the control board. If the code continues, you will need to replace the control board 31949201. If the code is gone, you will replace the membrane switch WP316189B. Hope this helps. Read More...