Customer Questions and Answers for Spark Module by Whirlpool

Detra,

In the control panel on the right side as you are looking at it from the back is where the spark module will be found on this unit.

Hello Detra. You will need to use WPW10331686 for the spark module needed. Thanks.

Mike,

The wire harness for the igniters would be part number W10170249.

Alfred,

This issue would be a faulty control board on the unit which is part number 0309440.

Alfred,

If the oven igniter will not come on then this issue will be a faulty control board for the unit.

Hello Pat. You will need to test the temp sensor in the unit. If it checks out good, then you will need to replace the control board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Hello Brian,
You will need to test the temperature sensor WPW10181986 for a resistance of 1090 ohms at 77 degrees and would add 2 ohms for every 1 degree increase.

Hello Rosalyn,
You will need to see if the bake ignitor is sparking. If so, you will most likely need to replace the gas valve WPW10293048. If it is not sparking, you will need to order the spark module WPW10331686.

Chris,

If you are on LP gas you will want to make sure that it was converted to LP by tightening down the orifice and flipping the cap from Nat to Lp because it comes set for Nat. If this is not the case then you need to check to make sure that the burner shutter is set for the correct air flow of either LP open all the way or NAT 3/4 way open and make sure that there is proper airflow around the unit.

Hello Gary. Yes, they are the same part numbers.