Greg December 16, 2011 for Model Number 110.26932691 Hi; I bought this motor for my Kenmore Direct-drive washer, and wanted to make sure I installed it correctly. Originally there was a 'cardboard' looking shield somewhere between the motor and the mounting plate attached to the transmission case, in the area of the coupler. (It has an electrical warning on it as it extends out behind the start capacitor on the side of the motor). This is a different shield than the cardboard-like one under the motor. There are four rubber grommets between the motor and the transmission mount plate. I just can't remember what side of the four rubber grommets this shield is supposed to be on. Is it supposed to be on the side of the grommets closer to the motor, or the side of the grommets closer to the transmission? I installed it with the shield between the motor and the grommets. My concern now is that if I did this wrong, it might be blocking air-flow that (maybe) is supposed to flowing out of the end of the motor. Can you tell me which side of the grommets (motor or transmission plate) this shield is supposed to be mounted? Does it matter? Is it even needed in this case? Thanks; -Greg
1 Answer Hello Greg. Yes, the grommets should face the motor WP3352287 and not the transmission. It sounds like you have it installed correctly. Hope this helps. Read More...
Chief September 15, 2011 for Model Number LA6098XTW0 Whirlpool Washer How do you check the pump and motor to see if they run freely when you have the covers off the whirlpool washer Model LA6098XT0?
1 Answer Hello Chief. You will need to bypass the lid switch assembly W10820036 to run the washer with the cover off the unit. Hope this helps. Read More...
Boomtown September 05, 2011 for Model Number 11028902790 I got this washer with a busted coupling. I replaced it and tried to do a wash but when it gets through adding the water and should start to agitate it will make a buzzing sound and if I don't stop the washer it will through the breaker. But it came with a busted coupling. What do you make of it?
1 Answer Hello Boomtown. Check and make sure the pump, motor and transmission turn freely. If not, you may have a bad clutch assembly. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. Hope this helps. http://forum.appliancepartspros.com/washer-repair/3265-replacing-direct-drive-washer-brake-shoes.html Read More...