Jerry S. May 01, 2011 for Model Number MDG4000BWQ The dryer will start and run but the gas never lites to heat the air. What should I check?
1 Answer Hello Jerry. You will need to test the thermal fuses WP303395 and the flame sensor WP338906 and make sure they are good. They should read closed for continuity. Also, check the igniter WP33002789 and make sure it is getting hot enough to light the gas. Here is a link on how to use a multi-meter for the testing procedures. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Joe April 29, 2011 for Model Number pye4500ayw Dryer vent right to outside is clear not clogged. Works fine on timed mode.Sensor dry mode gets warm. Time varies when set on more dry,or other choices in sensor mode. Sensor replaced by dryer motor (fan)_lower front machine. Still doing same. Way to test sensor bar or should I look elsewhere for problem.
1 Answer Hello Joe. This answer was located on our Repair Forum, this is a free service in which technicians will assist with answering repair questions for our customers. Please use this link to assist in your repair: http://forum.appliancepartspros.com/dryer-repair/196655-timer-does-not-turn-off-end-permanent-press-cycle.html . Hope this helps! Read More...
Joe April 28, 2011 for Model Number pye4500ayw Sensor dry mode gets hot but doesnt dry. Sensor bar looks like it cannot go bad as is simple in looks. Timer of sensor dry mode seems to run at varied times. Any ideas?
1 Answer Hello Joe. It sounds like the venting system is clogged. You will need to check the vent and clean it out. Be sure and clean the pipe and the dryer both. Hope this helps. Read More...
Andy April 25, 2011 for Model Number MDG5500AWW Ordered a new sensor bar assembly. Any special installation instructions? Thanks
1 Answer Hello Andy. Just remove the screw holding the sensor bar in place and disconnect the wires going to the bad sensor bar. Reinstall in reverse order with the new sensor bar. Hope this helps. Read More...
Richard March 21, 2011 for Model Number MDG5500AWW The time dry mode works and the sensor dry mode does not work. How do I fix the sensor dry mode?
1 Answer Hello Richard. Make sure the sensor bar is clean, and the wires are hooked up and not broke. Hope this helps. Read More...