Dan Adams March 12, 2022 for Model Number SVE47600B Is the control membrane AP6010682/WP1002033 available in white?
1 Answer Dan, Thanks for the question!!! It appears that the manufacturer has only made the black part available as the white part number subs to the black part. Read More...
1 Answer Hello Danny. The oven temperature sensor is either short-circuited or doesn't have any continuity. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Sonia J February 09, 2017 for Model Number SVE7600 B 1. The clock on the board is not working. All the buttons work fine. Can I just replace the clock. If so, do you have the clock? 2. the downdraft fan is making a grinding loud noise. Should I replace the motor?
1 Answer Sonia, The part number for the oven control board on this unit will be WP71001799. As for the downdraft motor you will want to check to make sure that there is nothing that got down inside the blower and if this checks ok then the motor would be the issue. Read More...
Scott May 17, 2016 I need this same part with white frame. Our stove is white. Can I peel it off and put it on my frame?
Pennie March 04, 2016 for Model Number 74004044 Jen Air Gas Model # JGR 8855 ADS Looking for plastic cover for touch screen?? Switch membrane as mine is melted but everything works. Just looks unsightly
1 Answer Pennie, Unfortunately the overlay for the clock assembly only comes with the clock on your unit which is part number 5701M486-60. Read More...
Djc August 05, 2015 for Model Number JES9860CAS02 Vent fan will not turn on from control pad. Stove is a little over 2 years old and I have only turned the fan on about 20 times. Vent Fan is the only function on the control pad that does not work. I'm hoping that the plug to the motor is the cause. Any thoughts or experience with this problem? Thanks.
1 Answer Hello DJC. You will need W10314420 to order and replace on the unit if the button is bad. If the button is good, then you need to test for power to the motor. If there is power there, you will need to replace the motor. Read More...
Tommy W. June 11, 2015 for Model Number SVE47600W The clock can not be set. Nothing on touch pad works. The cooling fan and oven light works all the time. I have tryed a new relay board in back of stove and remanufacterd clock. This happened when the oven went though the cleaning cycle. What is the problem? thanks tommy
1 Answer Hello Tommy, This sounds like a touchpad or ribbon cable issue since most of the time the touchpad WP71002033 is the issue when the clock cannot be set. Read More...
John C December 02, 2014 for Model Number SVE47600W Error keeps coming up F7. Hit cancel and stops but in a few seconds the error of F7 comes up again. Just replaced this panel two years ago. Your reply would be appreciated.
1 Answer Hello John. F7 is for a shorted button. You will need to replace the membrane on the unit. Read More...
Sue November 13, 2014 for Model Number SVD48600W Have code f1 your info says check ribbon cable did that. Replace keypad, cannot find.
Dave November 13, 2014 for Model Number WW30460W I was told that "dusting" the Membrane Switch would most likely make the oven work again - what is meant by dusting - air/micro cloth and does the switch need to be removed to do so?
1 Answer Hello Dave. "Dusting" means to clean the membrane. You can try cleaning the ribbon cable on the unit, but most of the time you have to replace the membrane to repair the unit. Read More...