Jgrover February 29, 2012 for Model Number DV306LGW/XAA The dryer flame lights but then goes out after a couple seconds earlier one of your reps said to change the coils, I did this and still have the same issue, could it be the thermostat or something else?
1 Answer Hello Jgrover. You will need to test the thermostats and the flame sensor and make sure they are good. They should read closed for continuity. Also, check the igniter and make sure it is getting hot enough to light the gas. Here is a link on how to use a multi-meter for the testing procedures. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
1 Answer Hello John. Yes, the thermostat WP35001087 should have continuity. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
John August 22, 2011 for Model Number ned7200tw when dryer is turned on control lights up and timer counts down but nothing happens. will this part fix it? Also there is continuity threw this part.
1 Answer John, If there is continuity through the thermostat, then it's "good" and not the problem. Do you have any "codes" in the display ? Have you checked and made sure you have 240 VAC to the terminal block, on the back of the dryer. Check the door switch circuit (should be closed white to yellow with the door closed) and make sure the belt is on the drum and the belt switch on the idler assembly has a closed circuit. If all those check proper, we're going to need a control board WP35001153 . Good Luck and Thanks. Read More...
Paul July 20, 2011 for Model Number ned7200tw10 My dryer is less than 2 years old and will no longer get hot. Will this solve my problem?
1 Answer Hello Paul. Check and make sure you have 240 volts coming to the dryer. Check and make sure the unit is not set to Air Fluff. Also check the heater WP35001247 and thermal fuses WP35001092 WP35001193 and see if they are good. You can test these with a multi-meter MA-DM1. They should read closed for continuity. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...