Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Lid Switch Assembly by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18026649
Manufacturer Part Number: WP3949238

If your washer won't spin or drain, the lid switch may be broken. This safety switch prevents spinning when the lid is open. DIY repair in 5-15 minutes.

More
$45.30

IN STOCK
Ships Today Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Washer Lid Switch Assembly (Part Number: OEM18026649)

1 Answer

Hello Diane. You need to remove the lid switch WP3949238 and see if it is broken. If so, it will cause the problems you are having. Hope this helps.

Read More...

1 Answer

Jim, You need to check a couple of things, Check the lid switch actuator 350733 make sure its not loose, broken or missing. Check and make sure the screw that holds the lid switch to the top (on the side of the opening) is not loose or missing. Thanks and Good Luck

Read More...

1 Answer

Hello Phil. Yes, the lid switch WP3949238 installs under the top panel on the right side of the opening. Disconnect the power to the unit. Remove the two screws in the back corners of the control panel securing the control panel. Pull the control panel forward and flip it backwards. Next unplug the lid switch and remove the two brass colored clips securing the cabinet to the back wall using a flat blade screwdriver to pry them out. Pull on the front of the cabinet and slide the cabinet off the frame of the washer. You can now access and replace the lid switch. Reinstall in reverse order. Hope this helps.

Read More...
Norman for Model Number whirlpool super capacity plus

i have the whirlpool super capacity plus and purchased this lid switch assembly, AP3100001 (3949238). upon installing i noticed 2 differences in the new assy vs the older failed assy. the first, it was ~3 inches shorter, the second, it had a curved metal piece over the switch lever. there are no additional serial or model numbers on the washer. do i have the correct part? i believe if i pry off the metal, it may just fit, but it would be "dangling" vs secured onto the frame with the metal clipings of the housing.

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google