Parts for Ge CVW73612M1SS: Range Hood Parts

This optional charcoal filter helps reduce refrigerator odors and keeps internal air fresher for food storage. It installs in compatible fresh food compartments to help control smells between periodic replacements. What it does:

• Adsorbs and helps neutralize common food odors inside the refrigerator
• Improves overall fridge air quality to reduce odor transfer between foods
• May help with lingering smells after spoiled food is removed
• Intended for use only in models designed to accept this optional filter

• One charcoal refrigerator filter

• Refer to your refrigerator's user manual for the correct filter location and installation procedure
• Install with the refrigerator powered off if location requires accessing internal compartments
• Replace periodically per manufacturer recommendations or when odor reduction decreases
• Dispose of used filters according to local regulations

The Lamp Asm W/ Connector is an OEM part for GE range hoods. It is a lighting assembly that illuminates the range hood area, providing visibility while cooking. This part includes the lamp housing, bulb, and the necessary electrical connector to power the lighting.

Symptoms of a bad Lamp Asm W/ Connector include:

• Dim or flickering lighting in the range hood area
• Lamp not turning on at all
• Buzzing or humming noises from the lamp assembly
• Burn marks or discoloration on the lamp housing

Causes of a bad range hood lamp assembly can include burnt-out bulbs, faulty wiring or connections, or general wear and tear over time. Exposure to heat, grease, or moisture can also contribute to the premature failure of the lamp assembly.

This OEM replacement is also compatible with Hotpoint, RCA, and some Kenmore range hood models.

The Grease Filter is an OEM part for GE range hoods. Installed at the front of the hood, this removable filter is responsible for trapping grease, smoke and other residue before exhaust venting occurs. 

Causes of a faulty grease filter can include normal saturation over time, exposure to high heat methods, or accidental impact damage.

Symptoms of a bad grease filter include:

• Reduced or inefficient ventilation from the hood  
• Strange cooking smells not being adequately removed
• Visible grease and residue below the filter area
• Increased vent or duct buildup impacting airflow 

This genuine OEM GE replacement is compatible with additional Hotpoint, RCA and Kenmore range hood models.

This upper chimney is the replacement top section that restores the range hood's exterior cover and helps hide ductwork for a finished look. It replaces damaged, dented, or missing upper chimney pieces to renew appearance. What it does:

• Covers and protects the ductwork above the hood for a clean, finished installation
• Restores the hood's exterior appearance when the factory chimney is dented, bent, or missing
• Helps maintain proper airflow path by completing the hood enclosure
• Matches the original fit and attachment points for a straightforward replacement

• One upper chimney top section

• Disconnect power to the appliance before starting any work
• Handle sheet-metal edges carefully; wear gloves to avoid cuts
• Keep original fasteners; before finalizing

This damper assembly controls the oven vent airflow to help maintain proper cooking temperatures and vent steam. It replaces a worn or stuck vent flap so the oven can vent normally and retain heat as designed. What it does:

• Opens and closes the oven vent to regulate exhaust airflow during heating and cooling
• Prevents continuous heat loss when closed and allows steam/smoke to escape when open
• Common symptom: oven struggles to reach or hold set temperatures
• Common symptom: excessive heat or steam escaping from the front of the oven
• Common symptom: vent flap stuck open or not moving

• One damper assembly

• Disconnect power (and gas if applicable) before starting any repair
• Access typically requires removing the oven back panel or control panel—keep fasteners organized
• Verify damper orientation and smooth movement before reassembling

This is a range hood blower assembly that removes cooking grease and odors from the air. If the air is not being cleaned effectively, the blower assembly will need to be replaced. Check to make sure that the filter itself is not clogged due to cooking grease. If it is, it should be cleaned. If the blower is not running at all, run diagnostics to ensure it's the blower assembly itself that has gone bad and not another part. Unplug the unit from its electrical outlet or shut off the house circuit breaker prior to replacing this part. The replacement process is very easy and takes about 15 to 30 minutes from start to finish. A nut driver will be needed for this task.This part is a genuine OEM part that comes straight from the manufacturer. It is sold individually. The blower assembly is compatible with range hoods that are manufactured by GE.

This handheld remote control replaces a factory remote to restore convenient remote operation of compatible GE appliances. It provides button-based command input so you can select functions from a distance without using the appliance controls directly. What it does

• Sends wireless commands to the appliance to start cycles, change settings, or stop operation when the original remote is lost or not working
• Common symptom: no response or intermittent response from the remote
• Common symptom: unresponsive or stuck buttons on the original remote
• Works as a direct replacement when the original remote is identified as the faulty component

• Install batteries before use; remove battery insulation tab if present
• Follow the appliance owner's manual for any required pairing or setup steps
• Disconnect appliance power before opening control compartments or doing electrical work
• Dispose of old electronics and batteries according to local regulations