Parts for Kitchenaid KSSS42MDX04: 10 - Refrigerator Door Parts

This screw anchor is a small plastic fastener that secures panels and trim on appliances, preventing screws from stripping or pulling out. It provides a reliable anchor point for screws where threaded material is thin or absent. What it does:

• Creates a secure mounting point for screws in sheet metal, plastic or thin panels
• Helps prevent screw looseness, stripping, and parts that shift or rattle
• Commonly used to hold trim, panels, or interior components in place
• Works with compatible screws to distribute load and stabilize attachments

• Use the correct screw size and length; anchors are made for specific screw diameters—do not force oversize screws
• Align anchor in the prepared hole before driving the screw to avoid cracking the anchor or surrounding material
• Hand-start screws until seated, then tighten gradually—do not overtighten to prevent stripping or damage
• Disconnect power and follow appliance safety procedures before accessing internal panels

The Screw is an OEM part for Whirlpool refrigerators. This screw plays a small but important structural role, securely fastening the refrigerator door hinges in place.

Causes of a bad screw include normal wear and tear, repeated door opening/closing stress, or accidental damage during cleaning or servicing of the hinge area.

Symptoms of a bad hinge screw include:

• Loose or sagging door that does not close or seal properly
• Increased vibration or noise from the hinge area
• Difficulty opening/closing the door smoothly

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This refrigerator door gasket compresses against the cabinet to create an air-tight seal. Replacing a worn gasket helps keep cold air in, maintain set temperatures, reduce moisture and frost, and support overall efficiency.

• Forms a continuous perimeter seal so the door closes snugly against the frame
• Helps maintain consistent internal temperatures and proper humidity
• Reduces frost/ice buildup and exterior condensation around the door area
• Signs of failure can include torn or warped rubber, visible gaps, condensation or frost near the door, longer run times, or warming inside the compartment

• Unplug the refrigerator and clear items from the door for easier handling
• Warm the new gasket (room temperature, or gently with a hair dryer on low or warm water) to relax folds—do not overheat
• If retained by screws, loosen the inner-liner retainer, seat the gasket lip starting at the corners, then tighten evenly; for push-in styles, press fully into the channel
• After installation, verify uniform contact all around and adjust door hinges if needed; allow up to 24 hours for the gasket to fully conform

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.