Parts for Whirlpool 4KSRF42DTX2: 09 - Refrigerator Shelf Parts

This is the replacement cover for the refrigerator crisper lid. It restores a clean, finished edge and proper lid operation over the crisper bin so drawers open and close smoothly and contents remain covered.

• Replaces a broken or missing cover on the crisper-lid assembly
• Provides a finished surface and correct fit for the lid above the crisper drawer
• Helps prevent the lid from binding, popping off, or failing to close
• Common symptoms: cracked/missing piece, lid misalignment, difficulty opening/closing the crisper

• Disconnect power before servicing
• Remove food and crisper drawer(s) for clearance
• Release any screws or locking tabs, remove the damaged cover, and retain hardware as needed
• Align the new cover and secure it; avoid forcing plastic parts

Comes with two rollers and two eyelets

Comes with two rollers and two eyelets

This is a replacement 10-16-1 screw used to fasten appliance panels and components. It restores a secure fit for loose or rattling parts so panels and assemblies stay properly aligned during use. What it does:

• Secures panels, brackets, or small appliance components in place
• Helps stop rattling, vibration noise, or loose-fitting parts
• Restores proper alignment for doors, access panels, or internal assemblies
• Matches OEM thread and length for correct fit when replacing worn or missing screws

• Use the correct screwdriver or driver bit to avoid stripping the head
• Hand-start the screw to ensure proper thread engagement before tightening
• Do not overtighten; snug the screw until the part is secure to avoid damage
• Disconnect power to the appliance before accessing internal components

This 10-16 screw secures panels, brackets, and internal components in your appliance. Replacing a missing or stripped fastener restores a snug fit, reduces vibration and rattling, and keeps parts properly anchored for reliable operation.

• Provides 10-16-thread fastening for sheet metal, plastic, and bracket assemblies
• Direct replacement for a missing, worn, or stripped factory screw
• Helps address loose or rattling panels or covers that won't stay secured
• Supports proper alignment and retention of internal components

• Disconnect power; shut off water and/or gas before servicing
• Match the new screw to the original location and length; replace like-for-like
• Start threads by hand to avoid cross-threading; use the correct driver for the head style
• Tighten snugly; do not overtighten into plastic or thin sheet metal

Color: white. Measures about 21 inches wide by 7 inches high by 15 inches deep.

This part has been discontinued and is no longer available.

This is a replacement 10-16-1 screw used to fasten appliance panels and components. It restores a secure fit for loose or rattling parts so panels and assemblies stay properly aligned during use. What it does:

• Secures panels, brackets, or small appliance components in place
• Helps stop rattling, vibration noise, or loose-fitting parts
• Restores proper alignment for doors, access panels, or internal assemblies
• Matches OEM thread and length for correct fit when replacing worn or missing screws

• Use the correct screwdriver or driver bit to avoid stripping the head
• Hand-start the screw to ensure proper thread engagement before tightening
• Do not overtighten; snug the screw until the part is secure to avoid damage
• Disconnect power to the appliance before accessing internal components

Specs: 10-16 x 1/2 inch.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.