Room Air Conditioner Gasket & Seal

This door gasket seal replaces a worn or damaged refrigerator or freezer door seal to restore a tight closure and help maintain proper temperature. It helps stop air leaks that can cause frost build-up and higher energy use. What it does:

• Forms a replacement seal around the appliance door to maintain an airtight closure
• Helps reduce interior temperature fluctuations that can lead to frost or spoiled food
• Restores proper door alignment and sealing where old gasket is cracked, torn, or compressed
• Commonly used when you see visible gaps, drafts, or persistent moisture at the door edge

• Designed for a direct OEM-fit; inspect the door channel and mounting surface before installing
• Clean the gasket channel and door edge to remove debris for best sealing contact
• Warm the gasket slightly (per OEM guidance) if needed for easier fitting; avoid open flames

This Form Gasket 2 is a replacement sealing gasket designed to restore a tight, reliable seal where the original foam/form gasket has become compressed or damaged. Replacing it helps reduce leaks and maintain normal appliance operation. What it does:

• Replaces a worn or damaged foam/form gasket to restore proper sealing
• Helps prevent water, air, or debris from passing where the original gasket seals
• Commonly used where a formed seal cushions or closes a gap in the appliance assembly
• Address symptoms such as visible gaps, leaks, rattling, or improper sealing along the joint

• One Form Gasket 2 as shown

• Install in clean, dry area; remove old gasket and clean mating surfaces before fitting the new gasket
• Fit gasket to the formed channel or mounting surface per the appliance's service instructions
• Wear gloves to protect hands from sharp edges and to avoid contaminating the gasket surface

This terminal cover gasket seals the terminal block/cover on the appliance rear to keep moisture, dust and debris out of electrical connections. It helps protect wiring and maintain a safe, dry terminal area. What it does:

• Creates a weather- and dust-resistant seal around the appliance terminal cover
• Helps prevent moisture intrusion that can cause corrosion or electrical arcing
• Reduces risk of dirt, lint or pests contacting wiring and terminals
• Supports safer terminal connections by keeping the compartment cleaner

• Always disconnect power to the appliance before accessing the terminal cover
• Remove the terminal cover screws/cap and old gasket, then position the new gasket before reinstalling the cover
• Inspect terminals and wiring for damage or corrosion while the cover is removed; replace damaged components as needed