Roper Range / Cooktop / Oven Parts

This replacement bumper cushions and protects appliance panels and doors to reduce vibration, prevent chipping, and stop rubbing or rattling. It restores a quiet, secure fit where the original bumper has worn or fallen off. What it does:

• Acts as a soft stopper to prevent doors, drawers, or panels from banging or contacting metal surfaces
• Reduces vibration and rattling during operation
• Protects finishes from chips, scratches, and wear at contact points
• Helps restore proper alignment and snug fit where the original bumper is missing or compressed

• One replacement bumper (1 count)

• Clean and dry the mounting surface; remove any old adhesive or debris before installing
• Press the bumper firmly into place; some bumpers use adhesive backing or fit into a recess—verify fit before final placement
• If adhesive is used, allow time for proper bonding per adhesive instructions; avoid using the appliance until secure
• For safety, disconnect power to the appliance before accessing panels or doors

This is a fixed drawer guide that mounts inside the range body to support and align the storage or broiler drawer. It allows the drawer to slide in and out smoothly along a straight track. Replace this guide if the drawer is difficult to open or close, slides unevenly, or feels wobbly when extended.

Black plastic trim piece that covers the top edge of your range oven door. Replace if cracked, broken, or missing to restore the finished appearance.

Replace your range's insulation cap if it's cracked, broken, or missing. This protective cover installs over insulation to maintain proper heat retention.

Mounting bracket for gas ranges. Secures components in place. Replace if bracket is bent, cracked, broken, or missing to ensure proper installation.

This cover guide is a small trim piece that protects and guides nearby components, helping keep panels and moving parts aligned for smoother operation. It replaces a worn or damaged guide to reduce rubbing and improve fit. What it does:

• Covers and protects the guide channel or track from wear and debris
• Helps maintain proper alignment of adjacent panels or moving parts
• Reduces noise or rubbing caused by a damaged guide
• Restores secure fit where the original guide is cracked, warped, or missing

• Disconnect power to the appliance before starting any repair.
• Typically installs with snap tabs or a few screws; basic hand tools may be required.
• Align tabs or mounting points carefully to avoid breaking plastic clips.
• If clips are damaged, replace them before reassembly to ensure a secure fit.