Roper Tube Or Fitting

This fitting tube connects a section of appliance tubing to the service plumbing to restore a sealed fluid path and prevent leaks. It's a direct-replacement plumbing fitting used where small-diameter tubing joins a fixed port. What it does

• Forms a secure connection between tubing and a plumbing port to maintain water/condensate flow
• Stops symptoms like visible leaks, pooling water, or reduced fill/drain performance when the original fitting is damaged
• Provides the proper interface for OEM tubing size and routing in the appliance
• Helps restore normal operation without altering factory plumbing

• One fitting tube

• Disconnect power and shut off water supply before servicing
• Drain remaining water from lines to reduce mess and pressure before removing old fitting
• Hand-start fittings then tighten to OEM torque; avoid over-tightening which can crack ports or tubing
• Inspect connections for leaks after restoring water and power; re-tighten if needed

3/8 to 9/16

This replacement back-right gas tube routes gas from the valve to the rear burner for proper combustion. It restores the correct gas flow path so the burner can light and maintain a steady flame when installed correctly. What it does:

• Directs gas from the valve to the back-right burner for ignition and operation
• Helps achieve a stable, even flame at the rear burner when functioning
• Replaces damaged, bent, or corroded tubing that can disrupt gas flow
• Can resolve symptoms like weak or no flame at the rear burner and uneven heating

• One back-right gas tube

• Turn off gas supply and power before attempting any service
• Inspect fittings and gaskets; replace any worn seals to prevent leaks
• Tighten connections to manufacturer torque specs and test for leaks with a soap solution or gas leak detector