Refrigerator Panel Control Knobs Parts

Fridge not cooling or running constantly? A faulty defrost timer causes frost buildup and temperature swings. Most DIYers replace it in 15 minutes.

This mechanical temperature control thermostat regulates your unit's cooling by cycling the compressor on and off to maintain the set temperature. Replace a failed cold control when temperatures drift, cycling is erratic, or the knob no longer responds.

• Monitors cabinet temperature via a sensing bulb and opens/closes electrical contacts to control cooling
• Helps restore consistent temperatures and normal run times
• Typical failure symptoms: too warm or too cold, runs constantly or won't start, no change when adjusting the control
• May cause intermittent cooling or short cycling as it wears

• Disconnect power before servicing
• Access the control housing; note/photograph wire locations and transfer them one at a time
• Route the sensing capillary exactly as original; do not kink or sharply bend the tube; secure the bulb in its original location
• Set the control to a mid setting and allow temperatures to stabilize before fine-tuning

Vertical mullion assembly that covers the gap between refrigerator doors. Replaces cracked, broken, or loose door trim for a clean, finished appearance.

Fixes ice buildup in freezer and warm fresh food compartment. This bimetal defrost thermostat controls heater cycles to prevent frost accumulation.

If your dispenser light stays off or won't turn on, this control board restores proper illumination. Moderate DIY, requires clip release and wiring.

Freezer won't cool or runs constantly? This temperature control thermostat regulates cooling cycles to maintain proper temperature. Moderate DIY repair.

Fix a dispenser that won't switch between water, crushed ice, or cubed ice, or buttons that don't respond. This control board regulates all dispensing functions.

Replacement LED assembly restores screen illumination by replacing the TV's failed LED strips. Use this part to address dim, flickering, or uneven backlighting and improve overall picture visibility. What it does:

• Replaces the TV's backlight LED strips to restore even panel illumination.
• Commonly used when the screen is dim, has dark bands or spots, or the backlight flickers or fails while a faint image remains.
• Fits into the original LED channels and connects to the existing LED driver/board (direct-fit replacement when matched to correct model).
• Does not address unrelated failures such as main board, power supply, or panel matrix faults.

• Disconnect power and allow the TV to sit unpowered before starting—work only when fully de-energized.
• Handle the LCD panel and assembly carefully to avoid pressure damage; wear ESD protection when available.
• Verify LED operation before full reassembly (power up with the panel/coverings off only if you are comfortable and it's safe to do so).

Fixes refrigerator lights or compartments not working. This control board box houses the digital board that regulates all functions. Moderate difficulty repair.

Trim piece that secures the gap between refrigerator doors for a clean finish. Replace if cracked, broken, or missing to restore proper door fit.

Refrigerator not cooling properly or freezing everything? A failing main control board disrupts compressor and fan cycles. Moderate DIY repair restores temps.

Refrigerator not cooling or completely dead after a power surge? This main power control board restores electrical control to compressors and fans.

Fix unresponsive buttons or incorrect temperature displays with this refrigerator control board. Resolves SY EF error codes and restores proper cooling control.

Due to manufacturer changes harness supplied in kit must be used. On refrigerator models manufactured prior to 2016, the dispenser board may also need to be replaced.

Fridge not cooling or running constantly? This fresh food thermostat cycles cooling on and off. Replace if your refrigerator won't stay cold or overcools.

3 pin 60 minute