Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Freezer fan loud or not spinning? This evaporator fan blade circulates cold air over the coils. DIY-friendly repair with our video guide.
I had found that the fan in the freezer was making a lot of noise. Turns out the shaft was loose, causing the flan blade to wobble. Replaced the motor and fan and now it runs like a new unit. Read more
Washer won't fill with water or only fills with hot? The water inlet valve controls water flow into the tub. DIY repair takes about 30 minutes.
This is my third repair of this type. The first was a stand-alone washer and was very easy, because there was a plate on which the inlet valve assembly was mounted, and it was easily removed. This repair was on a Frigidaire stacked washer/dryer (laundry center). Stacked washer/dryers are typically purchased to save space and are often tucked into a closet. Be sure you can pull it out to access both front and rear. Remove drain hose from drain, detach water hoses, electricity and dryer vent... Read more
Replaces cracked or broken suspension springs that support the drum in front-load washers. Installs at top of tub assembly. Sold individually.
Replaced springs and shocks. Read more
Secures the shock absorber to the outer tub in your washer. Replace if the pin is broken, cracked, or missing to restore proper shock mounting.
With more difficulty and frustration than expected but it works fine now. Things learned: 1. Order only 3 replacement pins. One comes with the shocks that you can't be sure you see in the picture. 2. A circuit board in a plastic box mounted to the floor, left rear, must be removed by two screws to be able to get pliers onto the head of the pin more easily. This helps installation too. 3. A 1/2" deep socket pushed onto the retaining tab of the pin stays there while you pull with pliers from the... Read more
Creates an airtight seal on your freezer door to prevent warm air and moisture infiltration. Replace if worn, cracked, or causing frost buildup.
Installed freezer gasket. Read more
Small washer that fits on refrigerator door hinges to distribute weight and reduce friction. Replace if worn, cracked, or missing to restore proper alignment.
New Door Handle and the plastic spacers Read more
Replacement screw for refrigerators. Secures handles, panels, and internal components. Order if yours is missing, stripped, or lost during repairs.
Took about 5 min to replace the handle with the parts ordered. Thank you for the fast service. Read more
Assembly screw kit for refrigerators. Secures handles, shelf tracks, door hinges, and interior panels. Replace missing, stripped, or lost screws.
Replaced handles Read more
Slide track for refrigerator snack pan or deli drawer. Replace if cracked, broken, or worn from regular use. Ensures smooth drawer operation.
I research the part number and ordered it and it was here in 2 days. Read more
Left side slide rail for refrigerator snack pan or crisper drawer. Replace if broken, cracked, or damaged to restore smooth drawer operation. Sold individually.
Our contractor replaced the Snack Pan Slide and fixed it. Read more
This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.
It was easy to find the part on appliance parts pros. Once I found it I studied the diagram and determined that there were 3 screws in the drum that needed to be removed. I disconnected power and then removed 3 interior screws. Once I did that I removed the back cover and removed the single screw on the bottom side of the air duct that held it in place connected to the heat tube. I then reversed disassembly. I want to tell you this is a 2 person job. In order to assemble it you need to... Read more
Prevents leaks and seals your washer door during wash cycles. Replace if torn, moldy, or causing water leakage. Verify fit with your model number.
I replaced the door boot with a new one from AppliancePartsPros.com. The most difficult part was starting at the back end of the new boot onto the stationary rim, just in front of the tub. And then anchoring it in place with the existing spring from the previous boot. To start the boot I had to hook the top edge of the boot, where the arrow tab is, onto the rectangular projection on the tub rim and then roll the rubber boot edge down around the tub rim and hope the rim was going into the... Read more
Replacement 10-32 machine screw for securing panels, brackets, and internal components. Ideal for replacing missing, stripped, or damaged hardware.
Ordered Bake Element, Y04100019 (Whirlpool AP4283614) to replace a broken bake element on my 30-year old Jenn-Air Model S125 Downdraft Slide-in electric range. Received the element very quickly but it had been damaged in shipping. Called AppliancePartsPros to report this and they quickly shipped another element - very easy process. To install the element, I turned off the power to the range, put on rubber gloves (just in case) and removed the two sheet metal crews at the rear of the oven -... Read more
Fridge not cooling or excessive frost buildup? A faulty defrost timer may be cycling incorrectly. Straightforward DIY replacement restores automatic defrost.
After replacing both defrost thermo's, defrost control and temp sensor I replaced the defrost heater. fridge has not had an issue since, been only a few weeks though. hopefully this solves the issue. GE model #-GTS22JBPBRWW Read more
Clear plastic dairy door cover for refrigerator compartments. Replaces cracked, broken, or missing covers. Keeps butter and cheese organized.
I did not have the model number of the refrigerator! I looked everywhere, but I think it had been ripped off. This left me with the difficult task of trying to look through pictures of dairy doors and freezer shelves, armed with only the approximate dimensions of the pieces. I checked the the Q 'n' A sections for several parts and this helped immensely. I was able to find someone who had the same dimensions listed and I knew, based on the answer provided, which part to order. Thank you for... Read more
Sump hose connects the washer tub to the drain pump. Replace if cracked, leaking, deteriorated, or has holes causing water leaks during wash cycles.
I changed the pump and also discovered the coin trap was wearing thin because it was rubbing against the sheet metal. So I replaced that as well. It took about 15 minutes to remove the coin trap and pump and about 20 minutes to install. The shipping was amazingly fast. I received the parts the next morning. I'm talking I ordered the parts before noon, chose the "fast shipping" option and received parts the next morning around 8:30 AM. Read more