Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Get your dryer spinning smoothly again - install the Whirlpool 341241 OEM Drum Belt in minutes.
Unpluged dryer first. Then took the lint filter out and removed the two philips screws inside the lint filter lid. Then take a paint scraper just under the top of the dryer two inches from the left front corner and pushed in a little to release the snap connector and did the same on the right side. Then lifted top over. Then take a 5/16 socket or nut driver and remove the two screws on on the left inside panel, then the right side. Lean front out a little and remove the two wires one the back... Read more
Fix uneven cooling or defrost issues with a new temperature sensor. Most DIYers complete this repair in under an hour with basic tools and our video.
I unplugged the fridge and took all the food and shelving out of the freezer and then proceeded to take off the bottom sliding drawer rack on both sides off (4 Phillips head screws). Then took off the light bulb cover and then the light bulb. Then the back wall that covers the coils and tubes that the refrigerant runs through ( 2 screws with hex head). After sliding out the back wall I could see that the entire coil area was frosted and iced up. I took a blow dryer and melted all of it over... Read more
Refrigerator not cooling but freezer works? A failed evaporator fan motor stops cold air circulation. Common DIY repair with video guide available.
Shut off power in the panel box - easier than getting at the plug behind the unit. Had to take out the lower full-width drawer and the two crispers next. Removed two screws on the shelf above the wide drawer and removed the two shelf parts. Next was removing a screw from each wide drawer support. Then I pulled the support forward about an inch to disengage it from a post towards the back. There is a wiring connection in the right-hand support you will need to disconnect. Next, I removed a... Read more
Freezer door gasket seals the freezer compartment to maintain temperature. Replace if torn, cracked, or not sealing properly. Confirm fit by model number.
I found the part number and ordered it. Read more
Protects and diffuses LED light inside your refrigerator. Replace if cracked, discolored, or causing dim lighting. Verify fit with your model number.
While waiting for parts for GE repair man to fix the fan issue the interior lights acted up, first one flickered and then went out followed by all the rest going dim. After reading stories on your web site, I ordered a couple of replacement lights and after installing the burnt out one they all came back to full strength! Thanks for the info and parts! Read more
Removes contaminants from your refrigerator's water and ice. Replace every 6 months or when the filter indicator activates. Confirm fit with your model.
Replaced filters Read more
Freezer thawing or frost building up inside? This defrost thermostat monitors coil temperature during defrost cycles. Easy DIY fix with video guide.
Replaced fan motor in fresh food section, easiest repair I have ever made, took longer to get shelves out than replacing motor.. Read more
The Run Capacitor is an OEM part for GE refrigerators. It plays a crucial role in the refrigerator's cooling system by providing the necessary start and run voltage to the compressor. Without a properly functioning run capacitor, your refrigerator may struggle to maintain the desired temperature, leading to spoiled food and inefficient energy use. Causes of a bad run capacitor include electrical surges, wear and tear over time, or overheating due to a malfunctioning refrigerator compressor or poor ventilation. Symptoms of a bad Run Capacitor include:
This OEM GE part can also be used on Hotpoint, RCA, and Kenmore/Sears appliances.
We replaced the main circuit board and the LED started to work and the condenser fan worked, but all we had were relay clicking sounds, but no cooling. The compressor had become so hot trying to work when the main circuit board was amiss, that it had popped the over temperature sensor on its side. As some one point out, if you remove the PTC+OLP assembly with the capacitor on it, and shake it, you will hear a rattle inside---and that is bad. We ordered a second round of parts from... Read more
Interior light not working when door opens? This light switch controls refrigerator illumination. DIY-friendly install takes 30-45 minutes with video.
I ordered a new switch from APP and fixed my fridge. However, the video posted for this repair on this site is not applicable to newer refrigerator models. I have a 2015 GE GTE18IHCRSS and had to drop the control housing (#432 in the diagram) to attach the wire/plug assembly to the switch. Only had to remove the front screw with a 1/4" nut driver and that provided enough of a gap for me to plug in the switch. So the correct method to replace the light switch in a newer model refrigerator is as... Read more
Fix excessive frost buildup on evaporator coils with this defrost heater. Solves cooling issues and frozen drawers. Moderate DIY repair with video guide.
Ordered a new evaporator fan, heater coil and fresh food fan. Troubleshooting on youtube, ordered the parts watched the video on how to remove old parts and then how to replace them. Called 3 different repair companies, seems no one will work on this GE French door fridge. I am sure someone with experience could change everything quicker! However, my daughter and I got the job done and the fridge is working great again! The videos on the parts ordering were the biggest help, straightforward and... Read more
Fridge completely dead with no lights or display? Main control board manages temperature, defrost cycles, and fan operation. Most DIYers complete in 10 min.
Replaced the main control in about 10 min and was up and running Read more
Dryer won't start or stops heating? This thermostat and thermal fuse kit fixes no-heat and no-power issues. Easy 30-minute repair with video guide.
I posted the following on the Facebook page ; SOoooo my 10 year old clothes dryer stopped and like almost everyone else I just figured it's shot, burned up, gotta get a new one. Well, due to a few bumps in the road I cannot afford another problem. My 2 vehicles are not running and with one being in the shop for 3 weeks and not being able to afford a rental car anymore this dryer was another headache. It sat for weeks and laundry started piling up. While looking online for sales somehow I... Read more
Seals the refrigerator fresh food compartment door to maintain temperature and prevent warm air entry. Replace if torn, cracked, or loose. Verify fit.
Easy to replace after watching the video Read more
No water from dispenser or ice maker? The water inlet valve controls water flow to both. DIY-friendly repair takes about 2 minutes with basic tools.
Swapped out with a new valve, took about 2 minutes and just a small nut driver (crescent wrench, socket or even pliers would have worked fine). Easiest repair I've done. Read more
Clear glass cover that sits above the vegetable crisper drawer in your refrigerator. Replace if cracked, shattered, broken, or missing to restore storage.
Drop-In replacement crisper glass Read more
The Refrigerator Fan Motor is an OEM replacement part for GE refrigerators. It circulates chilled air within the main cavity and fresh food compartment to maintain even cooling temperatures for foods. Proper airflow is critical for energy efficiency as well as preserving the freshness and longevity of stored items.
Causes of a bad fan motor include failure of the electrical components or motor bearings over many years of operation. Dust buildup may also slow airflow and result in overworking the motor.
Symptoms of a bad fan motor involve:
This genuine GE OEM replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
First let me say that we have been having a warm ff section since this refrigerator GE Mod GFE27GGDEWW since new. It was purchased in July of 2014, three repair under warranty,-thermistor,mother board, and a shrug of the shoulders, nothing wrong. the ff fan started making noise last week, and after doing some research saw that GE has a service bulletin REF03-18 updating the fan to WR60X29099. the install went well. new fan is quiet, seems to have more flow, but the ff section is still warm.The... Read more