Cwe 4800Acb Parts

• Fridge too cold
• Too warm
• Fridge runs too long
• Freezer too cold

I unplugged the fridge and took all the food and shelving out of the freezer and then proceeded to take off the bottom sliding drawer rack on both sides off (4 Phillips head screws). Then took off the light bulb cover and then the light bulb. Then the back wall that covers the coils and tubes that the refrigerant runs through ( 2 screws with hex head). After sliding out the back wall I could see that the entire coil area was frosted and iced up. I took a blow dryer and melted all of it over... Read more

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

Shut off power in the panel box - easier than getting at the plug behind the unit. Had to take out the lower full-width drawer and the two crispers next. Removed two screws on the shelf above the wide drawer and removed the two shelf parts. Next was removing a screw from each wide drawer support. Then I pulled the support forward about an inch to disengage it from a post towards the back. There is a wiring connection in the right-hand support you will need to disconnect. Next, I removed a... Read more

It was after 11:00 at night a few nights ago, I couldn't sleep listening to the whining of the fan in the freezer, it was running and making noise sounding like waaoooww, waaaoww. It also sounded like grumbling of a garbage disposal. The refrigerator fan motor was so noisy it was keeping me up all night going on and off running really loud and about to fail. So I was desperate, and called AppliancePartsPros when I couldn't get to sleep near midnight because the fan was so noisy and Bud in... Read more

I found the part number and ordered it. Read more

Ordered a new one. Read more

While waiting for parts for GE repair man to fix the fan issue the interior lights acted up, first one flickered and then went out followed by all the rest going dim. After reading stories on your web site, I ordered a couple of replacement lights and after installing the burnt out one they all came back to full strength! Thanks for the info and parts! Read more

Replaced filters Read more

Purchased new shelf bin. Read more

Replaced the valve configuration. It was pretty easy. Read more

Replaced fan motor in fresh food section, easiest repair I have ever made, took longer to get shelves out than replacing motor.. Read more

We replaced the main circuit board and the LED started to work and the condenser fan worked, but all we had were relay clicking sounds, but no cooling. The compressor had become so hot trying to work when the main circuit board was amiss, that it had popped the over temperature sensor on its side. As some one point out, if you remove the PTC+OLP assembly with the capacitor on it, and shake it, you will hear a rattle inside---and that is bad. We ordered a second round of parts from... Read more

Ordered a new evaporator fan, heater coil and fresh food fan. Troubleshooting on youtube, ordered the parts watched the video on how to remove old parts and then how to replace them. Called 3 different repair companies, seems no one will work on this GE French door fridge. I am sure someone with experience could change everything quicker! However, my daughter and I got the job done and the fridge is working great again! The videos on the parts ordering were the biggest help, straightforward and... Read more

I ordered a new switch from APP and fixed my fridge. However, the video posted for this repair on this site is not applicable to newer refrigerator models. I have a 2015 GE GTE18IHCRSS and had to drop the control housing (#432 in the diagram) to attach the wire/plug assembly to the switch. Only had to remove the front screw with a 1/4" nut driver and that provided enough of a gap for me to plug in the switch. So the correct method to replace the light switch in a newer model refrigerator is as... Read more

Removed the old Articulating Mullion Assembly (part number WR17X25027) by removing two screws, sliding the assembly up and disconnecting the wires (plug). Reversed the process with the new Articulating Mullion Assembly. Read more

The fix went great. I replaced the right-side door switch and it works great. The switch came as a three prong, and the original was a two prong. I matched the two prong wires with/on where they go on the switch, and it worked great. Next is the left door gasket. I am letting the new door gasket lay flat for a few days to see if the folded kinks/creases will relax out. They do instruct to use very hot water to get the folded shipping kinks out of it and will try that as a last resort. Read more