Your privacy choices: We and our partners use cookies for analytics and ads. Decline all turns them off.
Privacy Policy · Do Not Sell or Share My Personal Information
Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Fixes dishwasher overfilling or not filling properly. This float rises with water to signal when the tub is full. DIY-friendly repair in under 30 minutes.
I first installed the inlet pump with no results. I then ordered a Control Switch and Float and Nut. This fixed the problem. Everything comes out so clean. I also replaced the filter which allowed me to clean debris around old filter. It is also easier to replace all these parts with the dishwasher pulled out and tilted on its side. I had to pull mine out to unplug power to the dishwasher. Read more
Hose clamp for securing water supply and drain hoses on the washer. Provides leak-free seal at hose connection points.
Replace faucet adapter, replace fill and drain hose assembly. You must remove outer cabinet to be able to route new hoses and access hose connections under tub. Read more
Reversible dishwasher door panel insert in black and white. Replaces dented, rusted, or worn door panels to refresh your dishwasher's appearance.
Bought new top and lower front panels, removed/replaced rusted out panels & now dishwasher looks good as new! Only $34 from Appliance Parts Pros. Better than spending $500 on a new dishwasher. Read more
Soap or rinse aid dispenser not opening? This wax motor actuates the dispenser door release. DIYers report 15-30 minute repairs with basic tools.
I found the videos on dishwasher repair that AppliancePartsPros offers and determined the likely cause of the problem. I removed the door cover and found soap caked on the back. I cleaned the cover and switched the wax motors to see if the clean rinse motor was good and ran a tested cycle. No improvement. I ordered two new wax motors for the Maytag dishwasher and those arrived in a few days from AppliancePartsPros. I replaced the old motors and ran a test cycle. The soap tray opened correctly.... Read more
Leaking around the pump motor shaft? This dishwasher impeller and seal kit stops leaks from worn seals. Moderate DIY repair with video guide included.
Ordered the replacement pump seal kit from AppliancePartsPros. I watched the online how-to video on their website. The impeller was slightly stuck on the motor shaft due to age but overall was amazed at how easy it was to repair. Thanks AplianePartsPros! Read more
Bottle with brush. Color: Black. Size: 0.6 fl.oz.
Replaced It With New One Read more
Size: 1/4 inch hex head, 10-12 x 1/2 inch.
This trash compactor is in our vacation home. We never use it and now we are selling the house. When I looked to replace it I was amazed at how expensive a new compactor would cost. I found the serial number on the current compact entered it and your web site came up. Your schematics were excellent and made the repair very easy! Read more
Type AB #8-18 x 5/8 inch thread-forming screw secures panels and components in appliances. Replace missing, stripped, or corroded fasteners.
It was very easy to fix after watching your video.. Read more
Fix a dishwasher that won't drain or leaks from the pump area. This pump housing assembly replaces the seal connection between motor and tub. DIY repair.
If your dishwasher door drops or won't stay open, the door spring likely needs replacement. Requires pulling the unit out. Takes 30 minutes typically.
I ordered the parts, deciding that if one spring had broken, the other one should probably be replaced at the same time. I followed the suggestion of ordering the door spring bearing given on the ordering page, and since I had not yet pulled out the dishwasher, did not know that it was not used in this older model. However, the order arrived quickly (4 days), and they are genuine Whirlpool, made in the USA, parts. The access to the sides of the dishwasher where the springs are attached... Read more
Replacement tub wheel assembly for dishwasher upper rack track. Installs on inner tub to support rack gliding. Needed when wheel is cracked or broken.
Replaced left hand rack adjuster. Read more
Upper spray arm keeps falling off? This retaining nut secures the dishwasher spray arm to prevent detachment during wash cycles. 2-minute fix.
Ordered a new spray arm (because the old one finally broke into two pieces after falling off several times, and this time the arm melted next to the heat coils) AND ordered the new nut because of all the information posted by other users (thank you). Had to use pliers to get the old nut to unscrew, but once it was off, getting the new nut in was easy. Then popped on the new spray arm, and voila, the next load of dishes came out much cleaner! Yay! Read more
Seal gasket for dishwasher inlet base assembly. Replace if you notice leaks, moisture buildup, or debris entering internal components. Confirm fit.
1. To fix the leaks from around the door, I replaced the upper and lower door seals. These were purchased in a separate transcation, so they are not the parts shown here. The upper door seal worked as intended, but the lower seal would not stay in place on the lower edge of the door during a wash. Therefore I cleaned the grease and detergent off the old seal, and installed using silicone sealer/adhesive. The plastic edge pieces for the lower seal were supplied with the kit, and they installed... Read more
This flat-head screw secures panels, brackets, or trim so they sit flush on your appliance. Replacing a worn or missing screw restores a tight fit and helps prevent vibration, rattling, or shifting components.
Fix a cracked or broken door handle that's hard to open or close. This dishwasher door handle typically takes 10-15 minutes to replace.
I installed the door latch assembly and handle. It worked fine after that. Read more
This is a small sliding draw bar that connects to the upper detergent dispenser mechanism inside the dishwasher door. It helps actuate the dispenser lid so detergent is released at the correct point during the wash cycle. Replace this part if the detergent dispenser fails to open during a cycle or if the slide mechanism is cracked or broken.
Appeared to be two problems: the latch was worn and one of the pins that slid in a guide on the actuator located in the inner panel had broke off. Detergent lid spring and pin appeared to be OK but decided to replace since I was aready working on it. I ordered all the inner panel mechanism from the control arm to the latch actuator on the inner panel. The repair was successful as the detergent dispenser now opens during its cycle. Read more
Opt-Out Request Honored
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.