Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Fix a washer that won't start or stops mid-cycle. This lid lock magnet attaches to the inner lid and signals the machine it's safe to run.
Usually ships within 4 - 14 days
Fix a washer that won't start or spin with this lid lock switch assembly. Direct replacement part restores safety interlock function. Moderate DIY repair.
Fix washer error codes or spin cycle failures with this motor control assembly. Controls motor speed and drum rotation. Moderate DIY repair.
Replace your washer's cracked, broken, or damaged top lid. This cover panel installs on the main cabinet to restore appearance and safety.
Replace your washer's outer tub assembly if cracked, damaged, or leaking. This main housing holds the inner basket and includes the bearing system.
Replace your washer hinge bushing to restore smooth, quiet lid movement and proper alignment. Fixes squeaky or misaligned lids. Confirm fit with your model.
Replaced lid safety switch, actuator and plunger. Read more
This clutch assembly transfers motor power to the dryer drum so loads tumble properly. It replaces a worn or broken clutch to restore normal drum rotation and reduce slipping or grinding during operation. What it does:
Includes leg, foot pad and locknut.
1.) Made sure BOTH Hot & Cold Water Lines turned off to Maytag Washer. (I have dual shut-off valve for those two water lines), 2.) Briefly ran Washer on Warm Water Setting, removing water pressure & remaining water from Hot & Cold water lines. 3.) Unplugged Washing Machine. 4.) Used Needle Nose Pliers to remove BOTH Hot & Cold Water hoses from the hookup on the back of the washer. 3.) Made sure I had an empty bucket, on hand, to catch remaining water that may come out of now-removed, hot &... Read more
Filters debris and sediment from incoming water before it reaches the inlet valve. Replace if clogged or missing to restore proper fill flow. Confirm fit.
The machine would not run a full cycle before it cut off and had the code "FE" and water was too high. The water inlet valve needed to be replaced since it was letting in too much water at time. The repair was easy. Unplug machine and turn off cold water. Remove cold water line and drain water into bucket. Remove back two braces located at the top on each end of machine This will allow you to move top cove back about one inch. Pull back top cover about 1 inch then lift off cover. Remove... Read more
Specs: 10 - 16 x .375
Replaced the Injector valve, nozzle and sleeve-in using new hose clamps Read more
I pulled the tub from my machine and separated the inner tub from the outer tub and knocked out the two bearings from the outer tub and installed two new bearings and a tub seal from this website... i do have to warn everyone that when you order a new seal, it comes with a new seal race that is inside the seal and looks like the seal itself. remember to remove the old seal race before you install a new seal. also keep the new seal race inside the seal when you install it. this seal will place... Read more
Ordered boot watched video had no trouble finding ,parts easily entered part num,no problems at all Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.