G E Profile Harmony Parts

Replacement drum support roller assembly for dryers. Supports and stabilizes the drum as it rotates. Replace if roller is loose, wobbly, or worn out.

Fix a washer that won't stop filling or leaks water with a new inlet valve assembly. Controls water flow during fill and rinse cycles. 30-minute DIY repair.

Transfers motor rotation to tumble clothes. Replace when belt shows wear, breaks, or causes slipping noise. Confirm fit with your model number.

Carries wastewater from the washer tub to your household drain. Replace if cracked, kinked, split, or leaking to restore proper drainage function.

Dryer not heating? A faulty thermistor inlet fails to monitor air temperature, preventing proper heating cycles. Direct replacement restores function.

Side vent kit for dryers with exterior vent trim and mounting interface. Replaces damaged, missing, or worn vent trim to restore side vent openings.

Fix a dryer door that won't stay closed or latch properly with this door latch body. Common repair for doors that pop open during cycles. Easy install.

This is a replacement mounting screw used to secure appliance panels and components, restoring proper fit and reducing vibration or rattling. Use it to replace a missing or damaged fastener for a secure repair. What it does:

• Secures panels, trim, brackets, or small components in place
• Restores proper panel alignment and reduces rattling or vibration
• Replaces stripped, missing, or corroded screws that cause loose parts
• Helps maintain electrical and mechanical connections by holding parts steady

• Turn power off and unplug the appliance before beginning any repair
• Use the matching driver or bit to avoid stripping the screw head
• Replace only with the same type and size screw for a proper fit
• Inspect surrounding parts for wear

Truss head tapping screw for washer assembly. Replaces stripped, corroded, or missing screws in various mounting locations. Essential hardware piece.

White trim that finishes the edge around your washer lid. Replaces cracked, chipped, or broken trim that catches clothing or prevents smooth closing.

Replacement fastener washer for washers. Spaces and secures components at connection points. Order if original is missing, worn, or damaged.

Duct assembly that channels hot air from the dryer drum to the exhaust vent. Replace if cracked, disconnected, or showing heat damage or wear.

This is a hot surface glow bar igniter used in gas dryers to ignite the burner flame. It heats up until it reaches the temperature needed to open the gas valve and light the burner. Replace this part if the dryer runs but produces no heat, takes excessively long to dry clothes, or if the igniter glows but fails to ignite the gas.

This display assembly powers and visually reports the appliance control status so you can see settings and feedback on the control panel. It restores readable on-screen information and enables the front-panel display functions. What it does:

• Replaces the control-panel LCD and power/display electronics so the screen lights and shows information again
• Commonly used when the display is blank, dim, flickering or showing garbled characters
• Resolves unresponsive or intermittent front-panel display behavior tied to the display module
• Interfaces with the main control board to present time, temperature, and mode/status readouts

• One complete display assembly (power/LCD) as shown

• Disconnect power to the appliance before beginning any work to avoid shock
• Handle the LCD and cable connectors carefully to avoid damage; flexing or scratches can affect operation
• Access typically requires removing the control console or console bezel—keep track of screws and fasteners
• If symptoms persist after replacement, test the main control board and wiring harness for faults