Ge Pshs6rgxc2ss Parts

Replace solenoid, flapper door and recess spring. Really only needed solenoid, but other parts were so inexpensive and I knew I would already be in there. Read more

Replaced with new parts. Read more

Thanks to the AppliancePartsPro, I ordered it online and received it quickly. I even used the step by step directions on how to replace the tube from the AppliancePartsPro website. Just be very careful and review the instructions first. Couple of important things: 1. Take a picture of the existing wiring and tubes before you take them apart. 2. *if* you remove the wires ( red and white plugs) from the valve, make sure you plug them back in correctly. 3. Do not pull or push the tubes hard. Use... Read more

The old Ice stripper had broken fingers. I realized that even with the new one I had to shave some of the plastic to allow the rotating arms to clear as they push out the ice. I did this very easily with a box cutter razor blade. the Compartment tray was merely a remove and snap into place. Read more

Spliced new and old power cord near the connections in the fridge and connected them. Didn't mess with the factory harnesses or connections inside actual fridge. Read more

Ordered right hand bucket glide and complete ice bucket assembly (cost more than just the cover, but did so in case other ice bucket assembly parts were worn out). Replacing bucket glide was done relatively easily by first turning off the icemaker, removing the old ice bucket assembly from the glides, removing all screws on the right hand glide, and loosening the screws on the left hand glide. This allowed the drive motor assembly (which fits in slots at the back of each glide) to move enough... Read more

Replaced compressor with kit an relay, capacitor. Read more

Replaced with new parts. Read more

Pictures on website were great. I ordered the part needed. Very easy to replace. Read more

The auger gearbox shaft had a spot that was stripped of threads which prevented the auger drive from spinning the ice down the chute. I replaced the auger motor/gearbox assembly, the auger drive as it had to be cut off the shaft, and the 3 mount bolts that hold it all in place. Whole job took 30 minutes from start to finish which included cutting off the drive bracket. Read more

The video was helpful and took about 5 minutes Read more

Great site to DIY! Purchased fresh produce drawer railing and parts. Fixed in under 10 minutes. Thanks so much! Read more

My husband ordered and replaced the water tank inside the refrigerator in the back. Read more

Ordering the above parts I was able to solidly secure and align fan which got me up and running. Easy fix. Read more

Easy fix, just like replacing an old water filter. Read more