Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Reversible door plug fills unused mounting holes when switching refrigerator door swing direction. Replaces broken or missing plugs for a finished look.
Replacement mounting screw for refrigerator panels, brackets, door handles, and trim. Needed when original hardware is missing, stripped, or corroded.
Seals your freezer door to keep cold air in and moisture out. Replace when worn, torn, or loose to restore temperature control and reduce frost buildup.
The gasket seemed to be worn out. So I replaced it. Read more
Refrigerator clicking but not cooling? A failed overload protector can prevent compressor startup. This part interrupts power during overheating.
Replace this freezer door gasket when you notice frost buildup, warm spots, or the door won't seal tightly. Creates an airtight magnetic seal. Verify fit.
Creates an airtight seal around your refrigerator door to prevent air leaks. Replace if you notice moisture, poor sealing, or temperature issues.
We followed the video that you had on your website. We removed the door, removed the old gasket, and installed the new one. It took about 20 minutes total. Piece of cake! Read more
Replacement mounting screw for refrigerator panels, brackets, and hardware. Restores secure fit when original is missing, stripped, or corroded.
Hinge missing screws. Replaced 2. Perfect now Read more
Secures the evaporator fan assembly behind the rear freezer panel. Replace if cracked, rusted, or missing to restore proper fan mounting and clearance.
The problem was most likely the evaporator fan motor but it could have been a bad blade, loose parts or bad motor mounts. Hard to tell without taking everything apart and inspecting. Since fridge was 17 years old I decided to order the entire evaporator fan assembly as shown in the parts diagram including fan blade, motor brackets, motor, motor mounts, screws, etc. Getting to the assembly involved removing the ice maker unit plus the entire rear inside of the freezer section. Parts cost around... Read more
Cushions where the washer lid meets the top panel to soften closure and protect the finish. Replace worn, cracked, or missing bumpers to reduce noise.
Fridge won't cool or runs constantly? This temperature control thermostat senses compartment temp and cycles the compressor. Moderate DIY repair.
Replaced the thermostat. Read more
Secures the condenser fan motor in position. Replace this bracket if cracked, bent, or causing excessive vibration to restore stable mounting.
A replacement reversible plug door that covers and protects the appliance power inlet while letting the cord exit left or right for tidy cord routing. Restores a clean back panel appearance and helps keep the power connection protected from debris. What it does:
Secures evaporator thermistor to tubing for accurate temperature readings. Replace if broken or missing to restore proper cooling and defrost cycles. Confirm fit.
Secures refrigerator wiring to prevent chafing and vibration noise. Replace when damaged or missing to keep harnesses organized. Confirm fit by model.
8-18 CA HX 1/2 S
Replacement went good. The fan was perfect match. I am glad I ordered the two grommets, because the other ones were worn. I found this when dismantling. The blade was replaced as well. Read more
Refrigerator not cooling or running constantly? A damaged condenser coil prevents proper heat release. This assembly restores cooling efficiency.