Gu1200xtlse Parts

Replacement plate holder clip assembly that secures the appliance's glass plate or tray to the drive hub, helping restore stable, even rotation and reduce wobble or slipping during use. What it does:

• Secures the glass plate or tray to the drive hub so it rotates evenly
• Helps prevent the plate from wobbling, scraping, or slipping out of position
• Can reduce noisy or irregular turntable movement
• Supports consistent heating by keeping the plate aligned

• Disconnect power before servicing the appliance to avoid electric shock
• Remove the glass plate and turntable support to access the clip; handle glass carefully
• Press the clip onto the drive hub or shaft until fully seated
• After installation, reinstall the plate and run a short test cycle to ensure smooth rotation

This small plastic clip secures the cup shelf or fold-down tines to the upper dish rack in a dishwasher. It snaps into place to hold the shelf assembly firmly so cups and small items stay supported during the wash cycle. Replace this clip if the cup shelf is loose, falls down during use, or if the original clip is broken or missing.

White toe panel that covers the bottom front of your dishwasher. Replace if cracked, discolored, or missing to restore a finished appearance.

Right-hand door hinge that restores proper door alignment and smooth operation. Replace if your dishwasher door sags, binds, or won't stay open. Verify fit.

Replacement mounting screw for dishwashers. Secures internal components and panels. Order a new screw if yours is stripped, missing, or damaged.

Replacement mounting nut for dishwashers. Secures internal components and panels. Order a new nut if yours is stripped, missing, or damaged.

This is a rubber gasket that seals around the door vent opening on a dishwasher, preventing steam and moisture from escaping into areas where they can cause damage. It fits between the vent assembly and the inner door panel. Replace this gasket if you notice moisture or steam leaking from around the vent area, water dripping down the front of the door, or if the gasket appears cracked, warped, or deteriorated.

Outer door panel for dishwashers. Installs on the front of the dishwasher door. Replace if scratched, dented, or to change color finishes.

Controls water level and prevents overfilling in your dishwasher. Replace if you notice leaking or overflow issues. Confirm fit using your model number.

Internal rear feed cap for dishwasher spray arm system. Replace if damaged, cracked, or water leaks from the rear feed area. Confirm fit with your model.

Fix a dishwasher that won't fill properly or overfills with this overflow switch lever. Restores water level detection. DIY-friendly repair.

Replacement outer door panel for your dishwasher. Installs on the front exterior of the door. Order when your panel is cracked, dented, or damaged.

Filters lint and debris from wash water before reaching the drain pump. Replace if cracked or clogged to restore proper draining. Confirm fit by model.

This rinse aid sensor detects the presence/level of rinse aid and signals the dishwasher control so the dispenser and cycle logic respond correctly. Replaces a failed sensor to restore proper rinse-aid detection. What it does

• Acts as a reed-style sensor that notifies the control when rinse aid is present
• Helps the dispenser and control board make rinse-aid–related decisions
• Commonly replaced when rinse-aid indicators fail or rinse-aid detection errors occur
• Small, low-voltage sensing device used in the dishwasher dispenser area

• One rinse aid sensor (reed switch)

• Disconnect power to the appliance before starting any service
• Access may require removing the door inner panel or dispenser assembly; follow the service manual
• Handle gently and avoid bending the sensor leads; ensure secure electrical connections