Jtb86b0f3bb Parts

Ordered Bake Element, Y04100019 (Whirlpool AP4283614) to replace a broken bake element on my 30-year old Jenn-Air Model S125 Downdraft Slide-in electric range. Received the element very quickly but it had been damaged in shipping. Called AppliancePartsPros to report this and they quickly shipped another element - very easy process. To install the element, I turned off the power to the range, put on rubber gloves (just in case) and removed the two sheet metal crews at the rear of the oven -... Read more

• Freezer not defrosting

I took the bottom tray out of the freezer and found the coils iced up severely. I was reasonably sure the defrost timer was the problem and your tech said that was a good possibility. Ordered and replaced timer. (15 minutes) Problem fixed!!! Saved purchasing a new fridge at big bucks. We live over 40 miles from a service center so the cost of having a tech come out is astronomical. Thanks!!! Read more

Ordered the gasket kit. The shipping time was quick. The installation was more difficult than anticipated. The inside of the door had to be removed there were about 30 hex head screws. the new gasket then had to be fitted to the interior of the door and then placed on the outer part of the door and the screws replaced. The screw replacement took longer than anticipated as there were eight corner screws that were very difficult to manage because of the inside design of the gasket. The screws all... Read more

• Leaking

Replaced the broken parts. The water leak was caused by the drain valve not directed into drain pan Read more

After watching numerous videos I was able to discern that the problem was with one of the following: the timer, the heater, or the thermostat. a short time check showed me that the timer was working so that narrowed it down to the other two. Not having the necessary tools to check those two I ordered both parts. Once the parts came and I took out the old parts it was quite evident that it was the heater since it had black burn marks on it. I decided to install the thermostat also since it... Read more

Replaced the water tube that went from the plastic tubing to the ice cube tray. Found that even though it was the same exact length as the original, there was only an extremely small gap from the end of the tube to a splash board. This may have been the root cause of my problems. Read more

Ordered gasket and viewed video. My door was different and had screws holding inner door panel (just the plastic shelves). I easily removed the screws, the old gasket was easily removed, and the new one inserted without needing to perform any cutting or putty knife as shown on video. Read more

Replaced the temp controller Read more

I ordered a new gasket and my husband and I installed it. Read more

I ordered the part from you which arrived much sooner than expected. I replaced the Rail-Mulln. It was so easy to fix, next time I'll let my wife do it. Read more

Removed the top door hinge from the refrigerator as per the video on the website. Peeled back the old seal to get to and remove the hex head screws that hold the inner door liner/shelves. (I probably could have just torn the seal out before removing the screws.) The door seal I'm replacing is secured between the plastic door liner and the metal door. Due to seal leakage and ice buildup, the 8 screws on the bottom of the door were severely rusted. Was able to remove 7 of them with a nut... Read more

Ordered new Evaporator part and Drier from Appliance Pros. The part arrived earlier than expected and was properly packaged. I had both parts installed by a professional as they required a level of expertise above my capabilities. Works perfectly. Read more

• Freezer section too warm
• Fridge too warm

After watching numerous videos I was able to discern that the problem was with one of the following: the timer, the heater, or the thermostat. a short time check showed me that the timer was working so that narrowed it down to the other two. Not having the necessary tools to check those two I ordered both parts. Once the parts came and I took out the old parts it was quite evident that it was the heater since it had black burn marks on it. I decided to install the thermostat also since it... Read more

Popping the old draw glides off was the toughest part of the job, ad even that was fairly easy, once I noticed the little retaining tabs near the front of the drawer. Pushed in on the tabs, while pushing back on the drawer glide rail and it popped right off. One minor problem I did note: When the rollers were installed on the shoulder screws, they would not turn. One roller just had a burr around the inside edge of the hole. The other the entire bore was a bit undersized, creating a snug fit.... Read more

Used a muiltimeter to test all parts and ohm'ed out all parts. found out condenser fan motor seized up [open winding in motor] replaced that, and found that also caused the compressor overload and relay to fail, from over heating and over cycling, replaced both parts, powered up the refrigerator retested all electrical parts checked amp reading on all parts under load conditions,works good know, hope to get another 15 years out of this refrigator, its a maytag. over 20 years old. Read more

• Door won't open or close

Temporarily stuck a BMW lug bolt through the bracket and pivot opening to secure the door on the base, then waited just 3 days for the exact parts to come in from AppliancePros. Searching for the appliance model number brought me to the Appliance Pros website where finding the exact parts was quick and easy. Getting the correct part installed was a bit more involved as I had to remove and reinstall the bracket once the hinge pivot was installed, but it was quick and easy with my son holding the... Read more