Jvm1850m2sws Parts

Replaced Read more

Above the stove microwave took cover off microwave and checked all 4 thermals for continuity and they all passed put in new circuit board and the microwave was still dead went back to the thermals again and found cavity thermal had a blackened connector cut ends off wires and put together with wire nut and microwave worked put new connectors on wires and hooked up thermal tried microwave and it was dead thermal read continuity was good but thermal was bad replace with new thermal and wire... Read more

Plugged it in Read more

There are four screws that hold the handle in place, my handle was down to one. I had to pry off the inner door cover. I used butter knives, but a thin screwdriver should work as well. Start on the outside edge (away from the hinge) near, but not in, the upper or lower corner. Slip the knife in between the inner door cover and the outer door shell, gently pry loose, working around the cover. It isn't necessary to remove it entirely, but I did so that I could clean it. This exposes two of... Read more

Follow the trio ubshooting flow chart inside of the microwave panel - and read articles on this website. Turned out to be a thermostat that had popped and gone bad. Replace the thermostat and it is good to go. Read more

I had to remove the microwave from the range and then remove the cover from the microwave to determine the exact problem. After a visual inspection then discharging the high voltage capacitor, I used a meter to test the high voltage diode and fuses. After using the meter to ohm out the magnetron, I removed it from the unit, and seeing that the hole in the end of the magnetron's tube was enlarged and burnt, as if it was arcing, I assumed it was the bad part. I ordered the parts from Appliance... Read more

Asked a question on-line; received an answer in less than 15 minutes. Ordered replacement grill [w/o stainless steel front]. Price was the lowest I found. Received part in 2 days. Removed stainless steel front from old grill and installed on new part [be CAREFUL; SS metal front has very sharp edges!] Total time for replacement from taking old SS front off to final installation would have been only 20-25 minutes except two plastic lower tabs on new part were not molded correctly and would... Read more

Bought a new part from AppliancePartsPRO and installed Read more

Found a replacement stirrer motor from Appliance Parts Pros.com.The motor arrived in less than a week. I removed the old noisy motor and installed the new one. Placed a glass of water in the unit to test, and the new motor made it sound like brand new. The actual repair was quite simple. You just remove the grill on the top ,front of the unit. Take out the charcoal filter, remove the cover just under the filter( a single screw on the front is all that holds it in place. Unplugged the power... Read more