Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Water supply line connects reservoir to dispenser and ice maker. Replace if cracked, leaking, or damaged at connection points. Installs inside refrigerator.
Ordered new tube part AJR56656503 for Lg LFX25978ST/01 watched a lot of videos but none showed how to remove the door tube end from its connection so I just cut and spliced the new tube to the old under the cover for the door hinge area after feeding it from the back of frig to that area. It was easy till I tried to remove the line end from ice maker area. Read more
The Ice Dispenser Door Motor is an OEM part for LG refrigerators. This motor is responsible for the operation of the ice dispenser door, controlling its opening and closing mechanism to allow ice to be dispensed without letting warm air into the freezer.
Symptoms of a bad Ice Dispenser Door Motor include:
Causes of ice dispenser door motor failure can include electrical issues such as shorts or wiring problems, mechanical wear over time, or blockages that strain the motor.
This OEM LG part is also compatible with Sears/Kenmore.
Unplug refrigerator. Use non marring (plastic trim stick) tool to gently pry loose the plastic assembly containing the PCB display beginning at the lower edge and proceeding around the outer edge. Disconnect all connectors and note the routing of each wire harness and connector (take pictures on cellphone as necessary). Remove two screws holding inner PCB mount bracket in place to expose actuator, flapper door and linkage. Replace actuator (three mounting screws) and ensure that actuator... Read more
Refrigerator mullion door won't close or seal properly? This spring operates the center divider flapper door. DIY-friendly installation in 5 minutes.
Went looking for the spring for my refrigerator door mullion and it is not available for my model. Was told that I had to purchase the entire mullion for $130. Saw some videos on the web about replacing the spring making sure I got the one with the right number of coils. My broken one had 6 coils, I looked at the picture of the spring and counted six coils so I bought it and it worked fine. Read more
Plastic door stop that limits refrigerator door swing range. Replaces broken, cracked, or missing stoppers causing doors to swing too wide or close improperly.
1. Googled "appliance replacement parts" - found two sites to consider 2. Researched parts needed via a exploded diagram - can't fix it if you can't name it. 3. AppliancePartsPros.com had the easiest diagram and after checking, the lowest price. 4. Parts showed up within a couple of days - an in-transit note was helpful. 5. The part screws in but watch out you don't break the tiny black pin holding the part on in addition to the screw. Needed JB Weld to fix that. Read more
Insulating seal for bottom-mount refrigerator freezer doors. Replace if frost buildup, ice forming, or warm air entering. Confirm fit with your model number.
Replaced seal Read more
Dual roller wheel assembly that mounts to the rear wall of the freezer drawer. Replace when wheels are missing, broken, or cracked for smooth sliding.
With your part and 5 minutes. Quick and easy. Read more
Seals refrigerator door to maintain temperature and energy efficiency. Replace if torn, cracked, or not sealing properly. Verify fit with model number.
The right door seal and the freezer door seal are easily removed and replaced. They just pull out of the slot. These 2 new gaskets push in easily. The left door has the French Door Mullion, that blocks the removal of the door gasket. There are two screws in the middle that holds it on, and there is a spring at the bottom of the mullion that keeps the mullion in place. The spring can easily be removed, or left in place. There is an electrical connector in the middle of the mullion. As suggested... Read more
The Tray Asm is an OEM part for LG refrigerators. It is designed to store fruits and vegetables at optimal humidity levels, helping to keep produce fresh for longer periods. It has approximate measurements of 30 inches in length, 18 inches in width, and 4 inches in height.
Causes of a bad tray asm can include cracking or breaking due to frequent use, accidental dropping, or exposure to heavy loads that exceed its capacity. Over time, the plastic can also become brittle and more susceptible to damage.
Symptoms of a bad tray asm include:
This OEM LG part is also compatible with Sears/Kenmore models.
All three were replaced inside of 10 minutes. Read more
Fix no water or ice issues with this water inlet valve. Common when ice maker won't fill or dispenser trickles. Easy 10-minute DIY with video guide.
Replaced icemaker Read more
Fix a dispenser that won't stop running or fails to dispense ice or water. This switch activates your dispenser when pressed. DIY-friendly repair.
After my layman's diagnosis (hope) of a bad micro switch to the ice dispenser (would not activate and dispense ice through the chute) I purchased the both the ice and water dispenser micro switches (kill two birds with one stone). Albeit the video attached to these parts may be helpful to some it was not applicable to my refrigerator, as you could not access it from the front by removing the exterior dispenser plate. Don't try this on the LG, LFX25991ST series, refrigerator or you may break it... Read more
Stores and supplies water to your refrigerator's dispenser and ice maker. Replace if cracked, leaking, or damaged from mineral buildup or freezing.
Replaced tank assembly. Actually I think the supply hose was originally not fully seated in the tank and I think I could have re-seated it deeper through the gray bushing. When I set the line into the new tank, still leaking. Pulled out supply line and reset using a little more force and line went into the tank. Took the bushing clip off the other tank and used it for the supply line bushing. So far, no leaks. The thing to remember is to push the edges of each hose bushing inward to pull... Read more
The Thermistor Assembly is an OEM part for LG refrigerators. It serves a crucial function in monitoring and regulating the temperature within the appliance. By sensing temperature changes, the thermistor sends information to the refrigerator’s control board, ensuring the system adjusts cooling to maintain the desired temperature settings.
Symptoms of a failing thermistor assembly include:
Causes of thermistor assembly failure typically involve electrical faults, damage from moisture or frost, or simple wear over time, which can impact its ability to accurately measure and report temperatures.
Replace thermistor. Explained to home owner either thermistor or compressor since it was running hot but only 10 minutes to change out. Luckily client still has warranty on fridge to replace old compressor and thermistor. Read more
Spring for the ice door lever mechanism in your refrigerator's dispenser. Replace if the spring is stretched, broken, or missing and the ice door won't stay closed.
The ice chute flap wasnt closing. 1. I turned off power 2, Pulled off facia around controls on freezer door,, you have to pull out the bottom part of the chute first , its clipped in 3. Disconnected the front panel 4. Unscrewed the next panel to allow access to the chute flap 5. Removed 1 screw holding complete flap and mechanism and replaced with new 6. Re installed all parts in reverse Problem was the chute flap had worn and was folding over on top edge when opened and then wouldnt return... Read more
Hinge assembly for refrigerator doors. Installs at door pivot point to support door weight and enable smooth opening/closing. Replace if cracked or worn.
There is one hinge on top and one at the bottom, but it was none of these it ended up being this hinge that I ordered. Door was having a little hesitation at closing, the door would not pull your hand to close or it would not closed by itself. replaced this part and the refrigerator was fixed. Read more
Fix error code ER DH or ice buildup in your freezer with a new defrost control assembly. Regulates defrost cycles to prevent frost. Moderate DIY repair.
Your web site sent me the sensor. I watched the repair video that was excellent saved at least two hundred or more dollars.When I called Sears all they said was LG would not tell them what the error code was and they would send a repairman which would be $99 to show up plus parts and labor. Will always use your service! Read more
Refrigerator not cooling but freezer works? Compressor not starting? The start device provides electrical power to start the compressor. Basic repair.