Mdbh968 Parts

This control board housing secures and protects the washer's electronic control board, keeping circuitry stable and shielded from moisture and debris for reliable operation. It fits into the console area and supports proper control panel alignment. What it does:

• Holds and protects the electronic control board inside the console from impact, dust and moisture.
• Keeps the control board properly positioned for reliable electrical connections.
• Helps prevent control panel wobble or misalignment that can cause button or dial issues.
• Commonly replaced when housing is cracked, broken mounting tabs fail, or board access is needed.

• 1 control board housing

• Disconnect power and water to the appliance before beginning any repair.
• Handle the control board and housing carefully to avoid damage to connectors or circuit components.
• Use appropriate tools to remove console components; replace damaged mounting tabs and secure all fasteners.
• Discharge any capacitors and follow the board manufacturer's ESD/safety recommendations.

Dishwasher touch pad control panel mounts on the door and houses buttons and display. Replace if cracked, unresponsive, or buttons won't illuminate.

Dishwasher mounting bracket secures components inside the door panel. Replace if bracket is bent, cracked, or broken to restore proper alignment.

O-ring seal for dishwasher turbidity sensor. Replace if you notice leaking around the sensor or water pooling inside the dishwasher. Confirm fit with model.

Secures the upper wash manifold inside your dishwasher. Replace this clip if it's cracked, broken, or missing to restore proper support and alignment.

Inner door panel for dishwashers. Covers the interior door frame and provides structural support. Replace if cracked, warped, or damaged from wear.

Secures the heating element to the bottom of the dishwasher tub. Replace this bracket if it's loose, won't clip back into place, or has a flattened knob.

This manifold mounting bracket secures the gas manifold assembly to the appliance frame, keeping fuel lines and related components aligned for reliable operation. It's a direct-fit replacement that restores proper manifold support. What it does:

• Holds the gas manifold in the correct position to prevent strain on connections and lines
• Helps maintain stable alignment of valves and supply tubing to reduce leaks and intermittent flow
• Addresses symptoms like a loose or rattling manifold assembly or visible bracket damage
• Restores proper mounting after impact or corrosion-related bracket failure

• One manifold mounting bracket

• Install only with the appliance powered off and gas supply completely shut; follow local codes
• Match bracket orientation to the original and secure with manufacturer-specified fasteners
• Inspect nearby tubing, fittings and valve mounts for damage when replacing the bracket

Foam insulation strip seals the dishwasher door perimeter to prevent leaks and moisture entry. Replace if compressed, torn, or causing water drips.

This dishwasher door spring provides the counterbalance tension that lets the door open and close smoothly. Replacing a worn or broken spring restores proper door feel and helps prevent the door from dropping unexpectedly.

• Provides counterbalance tension so the door opens and closes smoothly
• Helps the door stay partially open without drifting
• Reduces slamming or sudden drop when opening
• Common failure signs: door feels heavy, drops quickly, opens unevenly, or a spring is visibly broken

• Disconnect power and shut off water; remove the toe-kick/access panel
• Support the door; note spring routing and which frame holes are used before removal
• Install the new spring in the same holes; adjust hole selection only per service information to fine-tune tension
• Springs are under tension—wear gloves/eye protection; consider replacing both springs together for balanced operation

Replacement lower spray arm for dishwashers. Installs at the bottom to direct water jets across the lower rack. Replace if cracked, clogged, or worn.

Color white. The wash arm measures about 11 inches, and the retainer about 3 inches.