Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This replacement screw secures panels, brackets, and other components in your appliance to keep them aligned and rattle-free. Replacing worn, stripped, or missing hardware restores a tight fit and helps maintain safe, quiet operation.
I ordered two replacement baffles and screws, then lifted the top of the dryer to access the drum and installed the two new baffles. Read more
Fixes weak spray and poor cleaning caused by a worn impeller. Mounts on the circulation pump to drive water through spray arms. DIY-friendly repair.
Motor shaft was stripped, replaced with new shaft from Motor Seal Kit. Impeller was also cracked, so replaced it as well. I did run in to a small problem, the chopper blade was pressing against the metal grate on the piece that goes back over the motor seal. I spent about an hour messing with it, but thought maybe once it's all together it'll be fine. When you screw the impeller on, it pushes down the seals, which pushes down the chopper blade. Video on Motor Seal Kit page made it an... Read more
Grey vinyl touch-up paint for repairing chipped, rusted, or damaged dishwasher rack coating. 4oz bottle with brush. Restores protective coating.
Used the vinyl touch up paint on the tops of posts and slid vinyl tips over 130 posts. The paint acts as an adhesive to keep the tips secure. Read more
Black access panel kit for dishwasher lower front area. Replaces missing, cracked, or damaged toe panel assembly. Secures under cabinet for finished look.
Kick plate was easy; screw holes in the wrong place, but used double-sided tape instead and worked great. Didn't need the extra screws ordered; it came with them. The roller spindles should be sent with a packet of grease. When replaced, the door was even louder than previous. Used candle wax on the spindles and it's quiet as can be now. Read more
Fix a dishwasher not filling with water or filling too slowly. This inlet valve controls water flow into your dishwasher. DIY repair with video guide.
Replaced the water inlet valve and float switch. Read more
Secures the wash arm to its support hub. Replace if cracked, broken, lost, or no longer holding the arm firmly in place during wash cycles.
Ordered a new pump Read more
Color: White. 4oz bottle with brush used for touching up damage to your dishracks. For blue use W10840471. For grey use WP676455. For tips use 675679
Ordered dishwasher rack tine tips and bottle of vinyl touch up paint. I applied the paint to each tine and then placed the tips on the tines. I waited a few hours before using my dishwasher to allow the paint to dry and allow the tips to stick to the tines. Read more
This is the heating element located at the bottom of the dishwasher tub. It heats the water during the wash and rinse cycles and provides heat for the drying cycle. Replace this element if dishes come out wet or poorly cleaned, the water is not getting hot enough, or if the element is visibly damaged or broken.
Number one was turn the power to the dishwasher off. I disconnected the hoses under the sink. The dishwasher had to be pulled out from the cabinet. The old heating element easily came out and the new one put in its place. The instructional video made the repair very easy. Read more
Dishwasher overflowing or not filling properly? The water level switch controls fill amount. DIY-friendly repair, typically 20 minutes with video guide.
Replaced float switch and also replaced intake valve. Worked like a charm and the process was as easy as the YouTube video I followed made it seem. Read more
Dishwasher leaking from bottom or making grinding noise? The sump housing often cracks or wears out. Moderately difficult repair, about 45 minutes.
I noticed the floor around the dishwasher was starting to get wet and warp the wooden floor. The chopper had gotten out of line and had cut a pinhole into the sump housing and the dishwasher was leaking badly. It was quite easy to repair. Just unhook the drain hose and the wire connectors, twist off the turbidity sensor and waste motor, pull out the shims and the whole assemple comes up and out. The hardest part was pulling the motor off of the assembly, since I wasn't sure if I needed to... Read more
Dishwasher not spraying or making loud buzzing noise? Replace the pump and motor assembly. Moderate DIY repair takes 2-3 hours with basic tools.
Checked the grinder/pump well at the bottom of the dishwasher and fished out some aluminum foil, wire twist ties, broken plastic forks, etc. That was fun but it didn't solve the problem. Purchased new pump & motor assembly and installed it as per Youtube video. It requires pulling out the dishwasher, disconnecting electric, hotwater, and drain lines, and then removing a bunch of clips and connectors. That was time consuming but basically easy ... except that seating the new assembly gasket... Read more
Replace worn or cracked door spring bushings that secure the tension springs on your dishwasher door hinge assembly. Essential for smooth door operation.
Purchased door springs from Appliance Parts pros.com, installed them and door on our Dishwasher was back to normal, Had to pull out dishwasher from under cupboard to get to springs, as they were on the sides of the dishwasher. Read more
Standing water or dirty dishes? A clogged or damaged pump inlet screen blocks debris from the wash system. Simple DIY fix restores drainage and cleaning.
Looked at Dishwasher. Scratched head and armpit. Told wife I would fix, not repariman. Wife skeptical - shook head. Found schematic on web. Found YouTube video of guy repairing same DW model. Disassembled. Diagnosed problem. Chopper assembly welded in place by water scale -broke removing. Potty mouth. Ordered parts. Waited for parts. Washed dishes by hand. Wife doing ok. Parts arrived (in only a day or two!!! Fed Ex for 7 bucks!! Great deal). Put on nasty t-shirt, baggy shorts. ... Read more
This factory-spec screw secures panels and components in your appliance. Replacing a missing or stripped fastener restores a tight, rattle-free fit so parts stay aligned and operate as designed.
Replaced Wheel-Tub. Read more
Fixes broken heating element brackets causing sagging or rattling noises in your dishwasher. Simple snap-on replacement restores proper element alignment.
Replaced spray arms and tube. Found all had debris in them and prohibited water pressure from reaching items. After replacement everything comes out sparkling. Don't understand how the spray arms getting plugged. Almost like waste water is recycled. Turns out to be a very easy project and if needed AppliancePartsPro has information and directions available at your finger tips.! Read more
Dishwasher not heating or drying properly? This heater probe shield protects temperature sensors and nearby components from heat damage for accurate sensing.
A bit of searching on the internet narrowed the problem down to either the heating element or the control board. As I am not much of a diagnostician I decided to replace both. Along this same line, I would never have attempted these repairs if it hadn't been for the clear, easy to understand repair videos provided for each part. Further, my decision to do my own repairs was made easier because the prices of the parts was so reasonable. I took my time, reviewed the videos and replaced the... Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.