Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Fixes ice buildup on freezer back panel and warm fridge temperatures. This defrost heater melts frost from evaporator coils. Moderate DIY repair.
IMPORTANT: Defrost heater was more difficult to install around the evaporator coils than the APP installation videos show, but it can be installed. See below. FIRST: Unplug the fridge/freezer! I tested the thermostat, mechanical defrost timer, and the defrost heater with a ohmmeter and determined that the heater was bad. NOTE: Thermostat must be cold in order to be tested; otherwise, the switch inside won't close and you won't get a reading from the ohmmeter. Take a can of compressed air,... Read more
Front cover for your refrigerator's ice bucket. Replaces cracked, broken, or missing covers to keep ice contained and ensure proper dispenser seating.
I ordered the parts needed from you and they arrived quicker than promised. your chat person was extremely helpful in finding the correct parts needed. Great service Read more
Ice dispenser not dispensing or crushing properly? The drive cam transfers motor rotation to advance the ice dispensing cycle. DIY repair in 30-45 minutes.
Initially I noticed the crusher drum was cracked and broken so I replaced the drum the retaining nut on the end of the auger and the circlip and washer. it worked fine for a time and then the drum began free wheeling. upon further inspection I discovered the retain nubs on the auger had worn down allowing the blade to slip down the auger body. so I replaced the auger, drum, drive blade, and drive cam. I recommend if you gave a problem with the ice dispenser you break down and inspect the entire... Read more
This controller kit is the appliance's main electronic control. It reads inputs from the user interface and sensors to power and coordinate key components. Replacing a failed controller restores responsive controls and consistent, reliable operation.
Replaced controller and starter relay Read more
Aluminum strap secures the defrost heater against the evaporator coil. Replace if broken, cracked, or missing to maintain proper heater contact.
Removed the freezer shelves and back panel, evaporator coils were frozen with ice. Defrosted coil and removed defrost heater connectors, measured no continuity in the heater and ordered a replacement. Also discovered the aluminum retention strap was broken and the heater had slipped down in it's position, ordered and replacement strap. Re-installed new heater and strap per the video instructions, repair complete. Most difficult steps were drilling out the drain pan rivet and re-threading... Read more
Covers the service opening on your refrigerator. Replace if cracked, broken, or missing to protect internal components and maintain a clean appearance.
Freezer drain tube that channels defrost water from the drain pan to the drip pan. Replace if cracked, leaking around the grommet, or causing floor leaks.
Replaced it Read more
Freezer not cooling or running constantly? This compressor kit circulates refrigerant through the system. Advanced repair requires refrigerant handling.
Purchased a replacement COMPRESSOR. The compress or was a replacement for MFG. P/N 5304478809. The compressor was not an exact replacement. There was no port identification so the connections took a lot of time searching the net and then only the suction port was noted. I had to operate the compressor to be sure of the discharge port.The start relay on the original had no power plug as the new one did so had to improvise by cutting the wiring and adding 1/8 push on clips and then sliding on to... Read more
Replacement screw that secures brackets, shelves, trim, panels, and covers inside your appliance. Install when the original is missing, stripped, or corroded.
Replaced the handle. Read more
Covers the factory test opening on your refrigerator cabinet or liner. Replace if missing, cracked, or damaged to restore a finished look and seal.
Spacer that fits between refrigerator door hinge components to maintain proper clearance and alignment. Replace if worn, cracked, or missing.
Tank itself is not included in this kit. Kit includes tubing,screws & two John Guess fittings & instructions.
I watched your video on YouTube and it was super easy after that, thank you for making this video. Read more
Replacement screw for securing panels, brackets, and covers on appliances. Replaces missing, stripped, or damaged screws to restore alignment.
This E-ring is a small retaining clip used in Frigidaire refrigerators to hold components on a grooved shaft or pin. It keeps assemblies secure and operating smoothly by preventing parts from sliding off during normal use. What it does:
Replaced auger nut , washer, and e-ring on end of auger. This allowed the auger to rotate correctly, and not "rub" the sides of the ice dispenser housing. Read more
Factory fastener that secures panels, brackets, and internal components. Replace missing, stripped, or corroded screws to restore tight fit and eliminate rattling.
Secures panels, brackets, handles, and trim inside your refrigerator. Replace missing, stripped, or damaged screws to eliminate rattling and looseness.
You have the best website and fastest shipping in the world---Thanks Read more