Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Our GE was installed about 8 years ago and was AWESOME for much of its early life. However, progressively its cleaning ability diminished. By replacing all the spray arms (clogged with debris), filters, drain hose, and sump...this dishwasher cleans like it did when it was new! Cost was around $100 (also replaced a wheel and the silverware basket) and labor was relatively simple. And to think...my mother-in-law said, "Wouldn't it just be easier to buy a new one?!?". Read more
The pump motor is located at the bottom of the dishwasher and circulates water through the spray arms while also draining water at cycle end. Replace if dishes aren't getting clean, water remains in the tub after cycles, or you hear unusual grinding or humming noises.
Replaced parts Read more
This specialized basket holds knives and sharp utensils safely during dishwasher cycles. It fits into your dishwasher's cutlery rack or third rack to keep blades secure and separated. Replace this holder when slots are damaged, the basket is cracked, or knives no longer stay properly positioned during washing.
Replaced all of the broken parts with the new parts from Appliance Parts Pros. Read more
The upper rack support comb is located along the dishwasher's upper track system and helps guide and support the top dish rack during sliding motion. Replace if the upper rack is difficult to slide, comes off its tracks, or tilts when loaded with dishes.
The inlet sump was deteriorating and pieces of it were clogging the spray arms. The gasket/seal on the bottom of the door was also deteriorated and clogging the filters. That seal was only available on a new inner door. It took a few hours because of the new inner door and I was taking my time doing extra cleaning and such. It was worth it because the dishwasher does an amazing job now and the wife is happy again. We wanted to avoid buying a new one because this one matches our other... Read more
Looks as if water seeped down onto the control strip and shorted it out. There were two traces in the membrane switch ribbon cable that were blown. Considered soldering them, but removing the control strip for inspection pretty much ruined the aesthetics of it, so just ordered another. You just have to unscrew the top mount screws to free the back panel of the door from the hinged inner panel of the door. Just lay the door flat open and unscrew everything facing straight up, nothing going... Read more
Replace the drain pump Read more
The instructions that came with replacing the detergent tank locknut were pretty clear. Separating the inner and outer surfaces of the door requires some care. The two surfaces are held together by a number of Phillips head screws. Once the two surfaces are loose, there is a ribbon cable, and a multi-pin IDC connector that connect the control panel on the front door, to the control module mounted on the inner door. You have to carefully disconnect the cables from the control module so as... Read more
Specs: 10 - 32 t hex 7/16 s
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.