Psfs2mjxb-Ww Parts

• Fridge runs too long

First, cleaned all the dirt and lint from the condenser radiator, the fan motor is in a metal housing holding the fan motor in place. look carefully and there is a sheet metal screw at the bottom of the housing, 1/4 inch screw head sheet metal screw. I removed the screw and that released the housing from the base of frig. then very carefully , I turn the housing with the fan motor still in the housing a worked out of the frig base where it would be easier to replace the bad motor. the... Read more

The indication was that when I tried to use the icemaker or water dispenser, the green LED on the front would dim and the ice maker dispenser wouldn't work. It was intermittent at first, but this indicated it may be a power management issue, in that insufficient voltage was getting to the ice dispenser motor. I unplugged the unit to reset the electronics for about a minute, and when I plugged it back it the compressor would try to turn on (solenoid or relay would click about every two... Read more

• Leaking
• Not dispensing water

We noticed a puddle of water in front of the fridge a couple of months ago-dried the floor up both times and thought someone had dropped ice-or spilled water. A couple of weeks ago there was water dripping through the dropped tile ceiling in the basement. I shut off the water for the water supply to the fridge at the copper pipe in the basement and removed some of the tiles which felt a little damp. It still dripped all day. When my spouse came home he pulled down more of the tiles. It was as... Read more

• Freezer section too warm
• Noisy

My refrigerator's cooling fan was making a noise. It wasn't loud; in fact, it was barely discernible. However, it was just loud enough to annoy me. The fan blade was hitting the shroud every now and then, creating a subtle, yet annoying sound. I'd tried tightening all the screws back there, and it helped-for a while. The noise came back. After looking at the fan motor, I noticed the bushings; it occurred to me that they might be the culprit. And why not? They were the originals installed at the... Read more

We replaced the main circuit board and the LED started to work and the condenser fan worked, but all we had were relay clicking sounds, but no cooling. The compressor had become so hot trying to work when the main circuit board was amiss, that it had popped the over temperature sensor on its side. As some one point out, if you remove the PTC+OLP assembly with the capacitor on it, and shake it, you will hear a rattle inside---and that is bad. We ordered a second round of parts from... Read more

Replaced two drawers, one shelf front, and the grille base Read more

I had started to order the part from GE at $34.95 + shipping when I did a search and found AppliancePartsPros.com. I was able to get the same part for half of the price of GE. I placed the order and actually to my surprise received the part the very next day. I watched the video provided on-line to see how to replace the part. It took me about 10 minutes and everything is working well. Beats paying a repairman to come out on their schedule and do the same thing at, I am sure, a much higher... Read more

• Freezer too cold
• Fridge too cold
• Too warm
• Freezer section too warm

Yes, a 49-yr old woman fixed this fridge all by herself! AppliancePartsPros was very helpful in the diagnosis of the problem, which I determined to likely be the result of defrost failure. There was a large amount of ice and frost coating the back of the freezer despite the inside temp being 42 degrees. My husband thought I was crazy to think it was a problem with ice when the temperature was warm, but I told him to trust me and I would attempt the repair. He just wanted to throw the old one... Read more

• Freezer section too warm

New cond fan & new evap fan & new defrost heater unit Read more

Followed the steps in the video. Just ensure you slide the auger forward so it clears the housing before trying to remove it. Read more

After disconnecting power to the fridge, I first removed the ice maker/water dispenser/fridge control faceplate. This easily popped out using a flat head screw driver. Then disconnected the 3 wire harness connections to the control board. I next removed the plastic dispenser housing shield. There's only 4 screws that hold this on. Finally, I removed the Micro-switch, disconnected the two wire connectors and installed the replacement switch and reinstalled everything. The repair took only... Read more

The freezer door on my 12-yr old GE side-by-side refrigerator/freezer would not stay completely shut resulting in temperature variations and ice buildup from outside humidity seeping into the freezer compartment. These problems were exacerbated by the fact that this appliance is located in my garage in the heat / humidity of the Atlanta, GA area. I applied a thin layer of petroleum jelly to the gasket which improved the seal but did not completely solve the problem. I discovered that... Read more

I ordered a new glass shelf late Friday afternoon and it was on my doorstep by Saturday! I really appreciated this because I was without a shelf in my fridge and was running out of space. I simply set it in place and was done with the repair. The cleanup of tiny pieces of glass in my sink, garbage disposal, and all over the floor took more time than the repair. Thank you Appliancepartspros.com! Read more

Part came in quickly. Fit right in. Read more

My refrigerator is 13 yrs old and began to build up frost in the ice cube shoot and the water tube began to freeze up over night. The flapper door was not closing completely. I simply removed the control panel by pulling up and out on the bottom edge, the edge is only about 1/8 inch thick, so don't reach in to far. You should be able to feel a small division line between the control panel and the refrigerator. No screw driver was needed to expose the 4 mounting screws of the inner dispenser... Read more

• Ice maker dispenses too much ice

First - I am not a handyman so bear with me. Turned out not only the auger fins were broken off but also the ice dispenser crusher cover had cracks and breaks on it. First - AppliancePartsPros.com has awesome shipping. Because i didn't know right away the crusher cover was broken, I had to do two orders. Each order was received next day in afternoon. Video is great. Tells exactly how to do. There are two issues you will run into. Remembering the exact sequence of all the washers and... Read more