Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
2 clamps included.
Fixed it myself. Took only 15-20 minutes to remove the old hose and connect the new one. The parts were exactly what I needed to make the repair. The repair video on the website was very helpful. Read more
Fix dishwasher not heating or running for hours. This NTC temperature sensor monitors water temp and prevents overheating. Moderate DIY repair with video.
Ordered new heater/thermostat piece. Read more
Fix a dishwasher that won't complete cycles or runs indefinitely with this control board. Controls all wash cycles and functions. 30-minute repair.
I ORDERED A NEW CONTROLLER BOARD. THE DIRECTIONS SHOWED HOW TO UNCLIP THE OLD BOARD BUT THE FASTENERS WERE ON THE LEFT SIDE NOT THE BOTTOM AS INDICATED ON THE REPAIR INSTRUCTIONS. AFTER REASSEMBLY THE DISHWASHER FUNCTIONED AS NEW. THNKS FOR THE INSIGHT. Read more
This metric M4 x 8 screw secures the toe-kick/lower access panel at the base of the appliance. Replace a missing or stripped fastener to keep the kickplate tight and aligned, helping prevent looseness and noise.
I went on your very user friendly website and looked up my bosch dishwasher. I love your diagrams and I felt confident that I could figure out what we possibly needed to get the door to close correctly and get the washer back working again. Your staff is courteous, service was fast and I would definitely recommend Appliance Parts Pros. Read more
Plastic cover that protects the drain pump mechanism from debris. Replace if cracked, broken, or tabs are bent preventing proper seal during drain cycles.
Watched AppliancePartsPros video, disassembled the dishwasher and replace impeller and seals. Read more
Replacement water feed tube that delivers water to the upper spray arm in your dishwasher. Replace if cracked, split at seams, or leaking due to wear.
After we saw that progressively our dishes were not getting clean we investigated the condition of the spray arms and this upper feed tube assembly. We found a huge crack on the side of this piece and new not enough water was getting to the arms. We also noticed a build up of soap and lime. So we ran a cycle of vinegar and sprayed the filters and arms with lime-off-sprayed them out with a air hose "completely". Many of the small pieces of lime will clog the holes in the spray arms. Attached the... Read more
This turbidity sensor detects how clear the dishwasher's wash water is so the control can adjust cycle time, rinses, and water changes. Replacing a faulty sensor helps restore proper cleaning performance and normal cycle lengths.
Replaced the turbidity sensor. I watched the video on how to replace the sensor. It took me a little longer than what service rep. said. But I finely finished the repair and now my wife has been using the dishwasher for the past week. I kept checking for leaks but so far so good. Thank you Appliance Parts Pros for your help. I installed the sensor on 08/18/2020. Don Read more
Fix a dishwasher that won't fill, overfills, or leaks from the base. Water inlet valve controls flow into the tub. Moderate DIY repair, 30-45 minutes.
Bacteria buildup in the venting assembly and drain hose. Replaced them and it's back to normal Read more
O-ring seal prevents leaks between dishwasher components. Replace when you notice water drips or moisture buildup. Confirm fit with your model number.
WE replaced the drain pump and it still wouldn't drain sometimes. Finally we realized that the drain hose wasn't the correct bosch hose and the rubber was starting to bend and kink where it went through the hole to under the sink.So we bought the drain hose and replaced. Read more
The Float is an OEM part for Bosch dishwashers. This float senses water levels inside the dishwasher, signaling the inlet valve to refill when needed.
Causes of a float malfunctioning can be mineral deposits accumulating and weighing it down ov
Replaced the defective float switch. Read more
Front-facing decorative facia panel for integrated dishwashers. Replace if cracked, chipped, scratched, or tabs are broken. Restores appearance.
Replacement. Read more
The Water Inlet Fill Hose is an OEM part for Bosch dishwashers. This part is responsible for safely and efficiently connecting the dishwasher to your home's water supply, ensuring that water flows into the dishwasher at the correct pressure and vol
Replaced the Water Inlet Valve and Drain Hose. Read more
Secures the dishwasher sump or sump cover to the tub for a tight, leak-resistant seal. Replace if missing, stripped, or damaged to restore stability.
Structural frame that supports the dishwasher user interface and front fascia. Replace if cracked, warped, or broken clips cause the console to separate.
Called ApplicancePartsPros and they immediately found the specific parts I needed for my Bosch model and shipped them across the US so I had them in just 3 days (all during the virus chaos)! On the website they provided a high-def, detailed video on exactly how to take it apart, install the new replacement panel, and put it back together. Easy and accurate. While I will never buy another Bosch, I will definitely use APP for all my future parts needs! Great customer service with Midwestern... Read more
Detergent not dispensing during wash cycle? This actuator arm with spring releases the detergent cup at the right time. Moderate DIY repair.
Ordered a replacement control panel and installed it according to the AppliancePartsPros.com YouTube video. Read more
Wax motor for detergent/rinse-aid dispenser.
Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks. Read more