Wrf736sdam Parts

First, I had to replace a cracked roller so I could roll the frig out. I did this by tilting it slightly and shoving a shim underneath. I had to use two shims to get enough clearance for the wheel. I unscrewed the old wheel, screwed in the new one pretty easy, removed the shims and rolled it out. Then I unplugged the frig from the power socket, removed 6 screws from the back panel, and pulled out the old drain kit, which had become clogged with dirt and dust. I put in the new drain kit,... Read more

Ordered replacement part Read more

Remove and replaced the auger motor, shaft seal, and the chute seal. No problem. However, the causing failure was to broken wire on the bottom of the freezer door. Loom and blue wire were cut, due to being pinched. I had current to start with and the auger worked three times then quit. That's when I really had to start searching . Fun. Read more

Replaced housing. That was simple but finding directions in how it I remove top of cabinet was time consuming. After two hours of searching I finally found one article that explained why there were no screws to remove. Read more

Bought new optic control boards, both the emitter and the receiver. The repair process was so simple. The KitchenAid repair tech came out to diagnose our issue. He was only going to come back and install a new emitter. They wanted a lot of money to do the repair. They were going to charge us $257 just for the part (emitter board). We bought both boards for $300 from AppliancePartsPros. We decided to replace both boards, because if one went bad the other might not be far behind. Read more

• Leaking

Thought leak was coming from icemaker but refrigerator was making ice just fine. had puddle on floor just below freezer door. upon closer inspection realized leak was coming from drain line. there were 2 pieces of tubing and the connector. leak was coming from where tubing goes into connector. wanted to replace it. didn't know what it was called. did live chat with someone I think was named James. he sent me diagrams and I could identify the part. once identified I ordered it. boom.... Read more

Popped old one off and snapped new one on Read more

Replace Read more

I purchased replacement parts to completely replace basket, face plate, and rollers. I received exactly what I ordered. The only problem I had was removing the part(s) from the shipping box. I thought the part came assembled (as rollers had been installed onto the basket), but the face plate had not been snapped into place. When I removed everything from the shipping box as one piece, the face plate fell off, hit the tile floor, and cracked. Bummer. Since the original face plate was in good... Read more

Evaporator fan was loud and eventually quit. This allowed the freezer temp to rise above 18 deg. which they activated the PF code. Replacing the evaporator fan motor fixed the problems. Read more

The storage device for water had a cracked fitting so when either the water or ice solenoid was activated the water ran into the compartment. I replaced the storage device (reservoir) once I figured out how to remove the upper cover in the top of the refrigerator. I needed to remove two screws located by the water filter these are the only fasterners needed to be removed, after that you need to pry down on the entire cover which is snapped in place, disconned the electrical connections and your... Read more