Vent Rotary Switch Parts

Seems like a poor design-hose developed a leak from rubbing on the support pad beneath it. Pretty easy fix if you follow one of the instructional videos online as far as how to get the front panel off of the washer. You can't change this part from the rear access panel. My washer and dryer are stacked so it added some time to the job. Read more

Https://www.appliancefactoryparts.com/content/pdfs/125631-1.pdf has the details to disassemble the dryer to access the vent part that cost apx$28. 1.5 hrs and some patience along with a screw driver and players was alll it took to to remove the cover, control panel, front cover, drum, belt, gas line and manifold assembly, flame tube? And rear drum panel in order to replace worn part. Reassembled in 15minutes to clean and vacuumed dryer. Works great now. Read more

I searched for parts on the internet regarding the make and model of my washer. Appliance Parts Pros not only had the part on a very user friendly website, but also had a well done video that made fixing the problem a breeze. Much appreciated and will buy from here from now on. Highly recommend! My local parts store did not have the part and would have to order it anyway. Read more

Replaced fill sensor and Main control board. Payed next day shipping and washer was up and running an hour after receiving the parts. Read more

• Will not stop filling with water

This error code indicated faulty water level and wash cycles were exhibiting either no water or too much water. Saw utube vid using this part for this type of problem and so far the repair is working well. Part arrived in 2 days, it was the right part and the machine is working the way its supposed to so I'm very happy. The worst scenario would have been to hire a repair guy to rip me off for a "Johnson Rod" I didn't need. Read more

Replaced the motor with a direct replacement part. The wiring was not the same because the switch on the motor was different. The instructions that came with the motor were enough for me to figure out what to do. Read more

Replaced hose that came with the new washer with this longer one. Read more

Tested float and input valve ohms both out of range replaced both parts units 3 years old Both parts did not fix problem Read more

Followed the instructional video on how to replace water pump. Also, as a back up measure we replaced the drain hose assembly thinking this may have been clogged with fabric softener residue. A success and wash machine works like it is brand new! No more fabric softener in this house again. Read more

I first checked a repair video and found the procedure was a 10 minute job. I then went to the website, put in my stove model number and searched for the switch. While I was looking I was offered a chat session with one of their experts. I am glad that I accepted. The switch I was looking at was not the right switch for the job. My expert verified my model number and the switch that need to be replaced. After a couple of minutes, she came back with the right part and placed the order for... Read more

It was easy to find the part on appliance parts pros. Once I found it I studied the diagram and determined that there were 3 screws in the drum that needed to be removed. I disconnected power and then removed 3 interior screws. Once I did that I removed the back cover and removed the single screw on the bottom side of the air duct that held it in place connected to the heat tube. I then reversed disassembly. I want to tell you this is a 2 person job. In order to assemble it you need to... Read more

It is difficult (if not impossible) to remove the electronic switches from the hard plastic latches. I replaced all three switches and both the upper and lower latches I also replaced the main 20 amp ceramic fuse which blew out when the latch/switches failed. Read more

Two screws remove the top. Unplug the wires to the old relay, give it a quarter turn and it's out. A five minute procedure. What took five hours was replacing the dryer duct work that I discovered was mostly crushed on its way from the laundry room, through a couple of walls to the exterior. Read more

You have to take the knob off the broken part, then buy the new switch element and fix it. To do this you turn the power off, take out 6 fasteners to release the front panel of the stove and replace the switch element. Then put it all back together. Very simple. But if the knob was designed better it would not have broken in the first place. It looks nice, but this is the third time I have had to fix one. Read more

Ordered Siphon Break Kit. Speedy shipping, thank you. Attached video shows how to remove front of washer to access screws to loosen top of washer to access siphon break from inside washer cabinet. http://www.do-it-yourself-washing-machine-and-dryer-repair-help.com/siphon-break-Maytagwasher.html Read more