Wall Switch Parts

Replaced those two items listed above, please continue reading! I'm a mechanic by trade, so I have the basics. And what made this job easy? Appliance parts pros! very easy access to Part numbers and Diagrams, Online help, Customer service, and the list goes on. You will see several other sites, However! Wouldn't it be nice, knowing the above? Go no further! If you get stumped on anything during your Maintenance or Repair, They will Help. Read more

• No hot or cold water

I tested the Atc. mid level switch, with my multi tester and found it was not sending enough current to the cold water inlet valve, so it would not open and let cold water in. I replaced the switch, (it was a snap) literally it snapped in place. replace the front face and turned the water back on and plugged in the washer, and turned it on. It worked perfect and has been since. good and easy repair even for a novice like me.. Read more

I ordered the lid switch and I recieved it within (2) days, I installed it and our washer is running again. Thanks to appliancepartspros.com. This is my second time that I have ordered a part from them at a reasonable price and quick delivery,I will use them again if I need another part for any of my appliances. Ricardo J. Rios Read more

Ordered the right part, took the back off the top control panel, and popped it in. Read more

Part easily replaced and problem was solved. Saved service call. Read more

• Doesn't shut off

Took out igniter module and porcelain was cracked. Replaced with ordered part and it worker fine! Read more

I changed out the oven temp probe located inside the oven, and I also changed out the temperature control which is located behind the oven temperature control knob. The whole process was simple, but it took a little bit of time since we repaired it ourselves and had to located these parts inside the oven. Read more

Removed control panel and replaced broken switch. Much easier then expected. Read more

I had removed three screws behind the control board cover of the washer, to access the old lid switch. I checked the continuety of the of the switch with a multimeter and it obviously failed the the test by displaying infinity of <1, rather than being 0. I removed the old switch with a flathead screw driver, I tested the new one and installed it in no time. Problem solved!!! Read more

Replaced the control that I think was bad from the purchase of the stove new as the burner didn’t throttle as is does now. Read more

Replaced the switch took a total of about five minutes. I pulled the stove out and turned the breaker off so I only had to pull it out enough to get a 1/4 " nut driver in behind it. Removed three screws and the back cover came off. I pushed the switch threw from the back and switched over the two wires then reversed the process. Completely easy if you can use a screw driver your crazy not to replace it yourself Read more

• Will not stop filling with water

Machine was a front load washer, after doing some research found that problem is usually caused by pressure sensor or the spider arm which attaches motor to tub. Read more