Briggs Stratton Small Engine Start Switch Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: W11050715
This replacement switch restores reliable on/off signaling to the circuit it controls, helping your appliance start, stop, and respond correctly. A worn switch can cause intermittent operation, no response, or lights and functions that don't activate. What it does:
- Provides an electrical open/closed signal to enable functions like starting a cycle, powering a motor or light, or shutting a feature off
- Acts as a safety/position interlock (such as door, lid, float, or hood) depending on the model
- Typical symptoms include won't start, won't stop, light won't turn on/off, or intermittent operation
- Can be checked with a multimeter for continuity when actuated
What's included:
Install notes:
- Disconnect power before servicing; turn off gas or water supply if applicable
- Access the switch, note wire locations, and transfer leads one at a time to the new switch
- Mount securely, ensure the actuator aligns and wires aren't pinched
- Reassemble and test operation before finalizing
More
$9.49
- Compare At:
-
$9.54
- You Save:
-
$0.05
Genuine Ge part
By: Ge
Part Number: WB24T10147
This is a high-amp SPDT (single pole, double throw) switch used in the oven door mechanism. It detects whether the oven door is open or closed and signals the control to enable or disable certain functions such as the oven light or broil element. Replace this switch if the oven light does not turn on or off when the door is opened or closed, or if the oven does not operate correctly in relation to door position.
Do-It-Yourself Stories from Customers like You
Faulty self cleaning latch Gregory K. • Bel Air , MD • December 28, 2016
Replaced faulty latch with new latch. New latch was different configuration, but the fit was okay. The only issue was that the wires to the electric motor were just barely long enough.
Overall easy repair if you have a T15 Torx bit, phillips screwdriver, and 1/4" nut driver. Hardest part is removing the gas cooktop to gain access to the cleaning latch. 0. Turn off electric to stove; remove the cast iron grates, center caps/orifices, and catch pans from the stovetop. 1. Disconnect the...
Read more
More
$23.30
- Compare At:
-
$27.49
- You Save:
-
$4.19
Genuine Whirlpool part
By: Whirlpool
Part Number: WP22001656
This is the washer's water level switch that senses tub level via air pressure and provides five selectable fill settings. Replacing a failed switch restores accurate filling and lets the cycle advance properly through wash, rinse, and spin.
- Monitors air pressure from the tub to detect actual water level
- Controls the inlet valves to start/stop filling at the selected setting
- Signals the timer/control to begin agitation and advance the cycle once full
- Common symptoms: overfilling or water keeps running, stops filling too soon or won't fill, inconsistent water levels, cycle won't advance due to incorrect level detection
What's included: 1 water level pressure switch with 5-position rotary selector Install notes:
- Disconnect power and turn off water supply before servicing
- Access the control console; remove the selector knob/dial and panel as needed
- Note wire locations (take a photo), move the harness, and transfer the pressure hose; ensure the hose is clear and firmly seated
- Securely mount the new switch, reassemble the console/knob, restore utilities, and test each fill level
Do-It-Yourself Stories from Customers like You
Water level in Maytag washer was always high and was not adjustable Von D. • San Bernardino , CA • December 21, 2017
Replaced the water level switch and water level pressure switch hose. Video on AppliancePartsPros.com detailed the procedure.
Read more
More
$127.65
- Compare At:
-
$153.18
- You Save:
-
$25.53
Genuine Frigidaire part
By: Frigidaire
Part Number: 318191000
Burner won't heat, stuck on high, or works intermittently? This cooktop burner control switch restores reliable on/off control. Easy DIY repair.
Do-It-Yourself Stories from Customers like You
I am buying a few new replacement parts for my frigidaire 40' range before the need arises they no longer make that size and i had my kitchen changed to fit this range e just iare William M. • Fishers , IN • January 23, 2016
I worked with Bud and he was most helpful. I was very happy with the service that was offered. I liked the quick shipment, good packing and only paying ONE time for shipping.
I would recommend your company again and would ask to deal with Bud again.
Thanks for you service.
Read more
More
$82.46
- Compare At:
-
$103.97
- You Save:
-
$21.51
Genuine Frigidaire part
By: Frigidaire
Part Number: 318394803
Has three terminals.
Do-It-Yourself Stories from Customers like You
Oven light stayed on when door was closed Robert S. • Jacksonville , IL • June 14, 2015
When trouble shooting the problem I found that the light switch housing outer lip was broken allowing the switch to push through mounting surface behind the oven door. This is a slide in range so, I proceeded to pull the range away from the counter where I could unplug the power cord. Once the power was off like located the panel on the right upper side of the unit and removed the screws to allow access to the switch. I then unplugged the switch from the wiring harness and removed the damaged...
Read more
More
$53.95
- Compare At:
-
$64.20
- You Save:
-
$10.25
Genuine Bosch part
By: Bosch
Part Number: 00611312
This switch is mounted on the dishwasher frame and detects when the door is properly closed to allow the wash cycle to begin. Replace it if your dishwasher won't start even with the door firmly closed, or if it stops mid-cycle unexpectedly.
Do-It-Yourself Stories from Customers like You
Dishwasher would not start. Jason M. • Florence , SC • November 30, 2020
REPLACED DOOR LATCH AND DOOR LATCH ASSEMBLY. EVERYTHING WORKS AGAIN.
Read more
More
$37.95
- Compare At:
-
$45.16
- You Save:
-
$7.21
Genuine Speed Queen part
By: Speed Queen
Part Number: 202937
If your washer overfills, underfills, or won't advance cycles, the water level pressure switch may have failed. Takes about 10-15 minutes to replace.
Do-It-Yourself Stories from Customers like You
Broken pressure switch Carole Y. • Yakima , WA • November 06, 2019
Bought part from you and got a repairman to put it in. Darlene of your staff found part I needed. Nice lady! Repairman charged $82 to do a 10 minute job. Not your fault!
Read more
More
$123.95
- Compare At:
-
$147.50
- You Save:
-
$23.55
Genuine Whirlpool part
By: Whirlpool
Part Number: 9871829
Fix a compactor that won't start, stops mid-cycle, or requires holding the pedal down. This drawer tilt switch is a quick 15-second replacement.
Do-It-Yourself Stories from Customers like You
Compactor would start sometimes by just closing the door when you start it by normally lifting the pedal it would not stop at the end of it's cycle Bruce H. • Hewitt , NJ • January 19, 2015
I replaced the upper switch that contacts the door in a closed position and more important the start switch contacted by lifting the start pedal.
Read more
More
$50.57
- Compare At:
-
$59.67
- You Save:
-
$9.10
Genuine Whirlpool part
By: Whirlpool
Part Number: W11162115
Burner stuck on high or won't regulate temperature? The infinite switch controls heat levels. Common DIY repair, typically 10 minutes to install.
Do-It-Yourself Stories from Customers like You
Switch was worn out Neil F. • Bellevue , WA • December 05, 2025
Replaced it myself after watching YouTube video. Simple and fast!
Read more
More
$78.27
- Compare At:
-
$92.36
- You Save:
-
$14.09
Genuine Ge part
By: Ge
Part Number: WR08X10112
Fix compressor clicking every few minutes or fridge not cooling. This start relay and overload combo helps your compressor start and prevents overheating. Easy 5-minute fix.
Do-It-Yourself Stories from Customers like You
Constant clicking sound from behind refrigerator and compressor would not kick on all the time freezer temp was above the desired temperature Peter H. • Bayside , NY • May 10, 2016
I replaced the old capacitor and combo device after watching repair video. Took less than 5 minutes and now my ge profile refrigerator is running perfectly.
Read more
More
$104.57
- Compare At:
-
$123.39
- You Save:
-
$18.82
Genuine Whirlpool part
By: Whirlpool
Part Number: W11662407
Fix a range hood that won't turn on, responds intermittently, or has a loose slider. This slide switch restores reliable control of fan and light settings.
More
$28.43
- Compare At:
-
$33.83
- You Save:
-
$5.40
Genuine Whirlpool part
By: Whirlpool
Part Number: WP12575501
This limit switch monitors a set condition and opens or closes its contacts when that limit is reached. Replacing a failed switch restores proper safety cutoff and consistent operation of the appliance's heating or movement system. What it does:
- Senses a limit condition at its mounting point (such as temperature or travel/position, depending on model)
- Changes state at a defined threshold to protect components and wiring
- Interrupts power to heat or motor circuits, or signals a control to respond
- Common failure signs: no heat or shuts down early, runs continuously, won't start, or intermittent operation
What's included:
Install notes:
- Disconnect power to the appliance before servicing
- Note wire positions; transfer connectors one at a time or take a photo for reference
- Reinstall in the original orientation so the actuator or sensing surface contacts the correct area
- Address root causes (blocked airflow, binding mechanisms, shorted components) to prevent repeat failures
Do-It-Yourself Stories from Customers like You
Water dispenser quit working Frank K. • Pass Christian , MS • February 20, 2017
I replaced the switch which was bad and also replaced the water inlet valve.
Read more
More
$49.51
- Compare At:
-
$58.42
- You Save:
-
$8.91
Genuine Whirlpool part
By: Whirlpool
Part Number: WP4387911
Fix a refrigerator light that won't turn on or off when you open the door. This push-button switch senses door position. DIY repair in 30 minutes.
Do-It-Yourself Stories from Customers like You
A failed freezer door switch was causing the fridge to display that the door was open when it was not this caused it to beep at random Kara H. • Charleston , SC • March 08, 2016
We actually were able to determine that one of the freezer switches was bad and taped it down for about 3 days. The beeping stopped. Our fridge has two freezer switches and one fridge side switch. I ordered all three from these guys. They were cheaper than Whirlpool by about $20 for parts and about $15 for shipping. The part numbers had superseded too many times to count, usually that doesn't matter but in this case it did. The new parts were just slightly bigger than the old parts AND...
Read more
More
$27.37
- Compare At:
-
$32.30
- You Save:
-
$4.93
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8268909
Dishwasher overflowing or not filling properly? The water level switch controls fill amount. DIY-friendly repair, typically 20 minutes with video guide.
Do-It-Yourself Stories from Customers like You
Washer would not fill with water Ty J. • Hillsboro , OR • July 08, 2018
Replaced float switch and also replaced intake valve. Worked like a charm and the process was as easy as the YouTube video I followed made it seem.
Read more
More
$50.57
- Compare At:
-
$60.18
- You Save:
-
$9.61
Genuine Whirlpool part
By: Whirlpool
Part Number: WP9763761
If your range burner won't heat, cycles incorrectly, or buzzes when turned on, a faulty infinite switch is likely the cause. Moderately easy DIY repair.
Do-It-Yourself Stories from Customers like You
Stems were broken on handles. Knobs didn't work correctly. Dan R. • Glendale , CA • May 06, 2020
Had to replace both switches. The hard part was getting the control panel off to get access. Only a few screws but even after getting them out, really struggled getting it off. After getting off, discovered that you need to get it lifted up before pulling it off.
Read more
More
$142.95
- Compare At:
-
$170.11
- You Save:
-
$27.16
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10274880
Fix a dishwasher that stops mid-cycle with a blinking start light. This door interlock switch restores reliable operation. 20-minute DIY repair.
Do-It-Yourself Stories from Customers like You
Kenmore ultra wash dishwasher worked great for 18 months; then would not run start button blinked 3 times and nothing happened Nick C. • Safety Harbor , FL • November 12, 2015
Looked online, appeared to be door switch or control panel. Tried door switch first, a $30 part. Installed new door switch and washer started right up and appears to be fixed. Have not tried full wash cycle yet, but problem appears to be fixed. I decided to buy part from AppliancePartsPros.com because I could return the part if it did not correct the problem, no one else offered such a deal. I will only deal with AppliancePartsPros in the future, they were extremely helpful on the phone!
Read more
More
$50.57
- Compare At:
-
$60.68
- You Save:
-
$10.11