Water Temperature Sensor Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WPY304474
If your dryer takes too long to dry or overheats, the cycling thermostat may have failed. This part regulates heat by cycling on and off. Easy DIY fix.
This part fixes the following symptoms
-
No heat or not enough heat
See more...
Do-It-Yourself Stories from Customers like You
It was taking unusually long to dry a typical load Robert L. • Williamsburg , VA • November 15, 2014
I removed the front panel and observed the heating element while running the dryer. It was cycling off every minute or so and staying off for several minutes. Even though it was likely the high temp cycling thermostat I replaced both the 14, and 15 cycling thermostats which I think are the original factory units. That makes them nearly 35 years old. Problem fixed.
Read more
More
$54.25
- Compare At:
-
$64.56
- You Save:
-
$10.31
Genuine Ge part
By: Ge
Part Number: WR50X133
Fix frost buildup and warm fresh food section with this clip-on defrost thermostat. Restores automatic defrost cycles. Moderate DIY repair.
Do-It-Yourself Stories from Customers like You
Top getting warm. Adam L. • Almond , WI • December 24, 2019
I bought a thermostat and defrost timer.
Read more
More
$68.95
- Compare At:
-
$81.36
- You Save:
-
$12.41
Genuine Lg part
By: Lg
Part Number: MEJ62284601
Joins dishwasher hoses to ports for leak-resistant connections. Replace this small connector if it's cracked, split, or loose to stop drips at the joint.
Do-It-Yourself Stories from Customers like You
Hose connector split. Michael T. • Hopewell Junction , NY • December 09, 2019
Did not have to remove the dishwasher, very tight quarters, it was a simple repair made a bit difficult because of where it is under the dishwasher,
Read more
More
$21.46
- Compare At:
-
$25.54
- You Save:
-
$4.08
Genuine Ge part
By: Ge
Part Number: WR17X12301
Holds water filter securely and directs flow to dispenser or ice maker. Replace if filter won't stay sealed, water flow is slow, or leaks occur.
Do-It-Yourself Stories from Customers like You
Leaking and water dispenser not working. Seyed Mani M. • West Bloomfield , MI • May 23, 2020
I ordered a filter housing, some plastic tubes to replace the leaking one and en extra connector which came really handy.
I followed the videos and replaced parts pretty easily. It could have been done in as little as 15 minutes. But I started getting leaks and took me a while to play with water lines and changing connectors to stop the leak. Then I had to test it a few times to make sure it won't leak again.
Read more
More
$67.95
- Compare At:
-
$80.18
- You Save:
-
$12.23
Genuine Ge part
By: Ge
Part Number: WR17X12512
Water filter head assembly holds the filter and connects water lines. Replace if you have no water flow or leaks. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
No water flow to water dispenser or ice maker John T. • Chester , VA • October 31, 2014
First, verified that water filter wasn't the problem by removing it and installing bypass plug. Second, verified that water was flowing from supply valve by disconnecting line to automatic water valve and observing flow into a bucket. Third, verified automatic water valve was functioning correctly by connecting supply line directly to automatic water valve. With the filter, water supply, and automatic water valve eliminated as problems, the filter head was identified as the problem by process...
Read more
More
$199.95
- Compare At:
-
$237.94
- You Save:
-
$37.99
Genuine Bosch part
By: Bosch
Part Number: 00755060
This meat probe sensor is a temperature-sensing device that inserts into food while it cooks in the oven, allowing the oven to monitor the internal temperature and automatically stop cooking when the target temperature is reached. It connects to a jack inside the oven cavity via a heat-resistant cable. Replace this probe if your oven no longer reads the food temperature accurately, displays a probe error code, or if the cable or tip is visibly damaged.
Do-It-Yourself Stories from Customers like You
Broken probe George K. • Saint Johns , FL • September 30, 2014
Replaced
Read more
More
$102.43
- Compare At:
-
$120.87
- You Save:
-
$18.44
Genuine Frigidaire part
By: Frigidaire
Part Number: 134786110
This moisture sensor monitors dampness inside the dryer drum and signals the control when fabrics are dry, helping automatic cycles end on time and avoid overdrying. Replacing a failed sensor can restore consistent Auto Dry performance and cycle times. What it does:
- Detects moisture level via conductivity across the sensor surfaces inside the drum
- Sends feedback to the control so Auto Dry cycles advance and stop correctly
- Helps prevent overdrying and underdrying in sensor-based cycles
- Common symptoms of a faulty sensor may include: auto cycles ending too soon or running too long, clothes remaining damp, or the dryer staying on "Sensing" while timed cycles still work
What's included:
Install notes:
- Disconnect power and, if applicable, shut off gas before servicing
- Access the sensor at the front bulkhead/lint housing area; remove front panel as needed per model
- Transfer connectors and route wiring exactly as original; secure the sensor firmly
- Clean the sensor contact surfaces with rubbing alcohol; residue from dryer sheets or fabric softeners can affect readings
Do-It-Yourself Stories from Customers like You
Clothes got stuck on moisture sensor bar and broke it off Felix M. • Kyle , TX • April 17, 2015
Fixed it in 5minutes.
One end has a Phillips head screw and the other has a tab with to metal leads for wires. The end with the tab broke. I removed the screw for the other end abd the sensor bar came off. To put the new piece on, I connected the wires to the leads, slid the tab end into place on the drum and screwed in the other end. Done! Easy!
Read more
More
$81.36
- Compare At:
-
$96.82
- You Save:
-
$15.46
Genuine Frigidaire part
By: Frigidaire
Part Number: 154762601
This dishwasher turbidity sensor measures how dirty the wash water is and reports to the control. Replacing a faulty sensor can restore proper cycle times and cleaning performance for consistent results.
- Monitors water clarity/soil level during the wash
- Sends feedback to the control to adjust cycle length, rinses, and heating
- Failure can cause very long or very short cycles
- Can trigger sensor-related fault indications
What's included: One sensor Install notes:
- Disconnect power at the breaker and shut off water before servicing
- Access the sensor from the bottom near the sump; remove the toe panel if needed
- Unplug the wire harness; release the locking tabs or twist-lock to remove; avoid touching the optical window
- Inspect and reuse the existing seal/retainer if in good condition; seat fully and check for leaks after reassembly
Do-It-Yourself Stories from Customers like You
Leaking from the door and around the sensor gasket. Michael S. • Franklin , WI • May 07, 2023
I replaced the sensor and the seals around the door.
Read more
More
$71.95
- Compare At:
-
$85.62
- You Save:
-
$13.67
Genuine Frigidaire part
By: Frigidaire
Part Number: 241998303
Secures the water filter housing to your refrigerator liner for proper alignment and sealing. Replace if cracked, loose, or causing leaks. Verify fit.
Do-It-Yourself Stories from Customers like You
Water filter wouldn’t stay in due to self induced heat gun related problem trying to de thaw an ice issue. Jason B. • Tampa , FL • January 28, 2023
Live and learn, never put items up against the back of your refrigerator stopping the airflow. I did this and caused the water line to freeze. In an attempt to fix it, I used a heat gun and accidentally warped the parts in the water filter assembly. By replacing all three of the items listed that fit perfectly the problem was solved.
Read more
More
$10.95
- Compare At:
-
$13.14
- You Save:
-
$2.19
Genuine Lg part
By: Lg
Part Number: 6322FR2046G
Washer not heating water or showing tE error? This temperature sensor monitors water temp and signals the control board. Moderate DIY repair fixes temp issues.
Do-It-Yourself Stories from Customers like You
Te error code on my kenmore elite washer Angela R. • Rushville , IN • February 08, 2015
Ordered a new thermistor and replaced the one that the wires had pulled out of.
Note- we secured the wires on the new thermistor with electrical tape before installing.
Read more
More
$39.95
- Compare At:
-
$47.54
- You Save:
-
$7.59
Genuine Samsung part
By: Samsung
Part Number: DD82-01100A
This water supply tube connects the water inlet valve to the wash system inside the dishwasher, delivering water for the wash and rinse cycles. It is a rigid or semi-rigid tube designed to handle the water pressure and temperatures inside the unit. Replace this tube if you notice leaking underneath the dishwasher, reduced water flow into the tub, or visible cracks and damage on the tube itself.
Do-It-Yourself Stories from Customers like You
I accidentally broke the locking tabs off of the bottom of the duct assembly and it would not stay in place. Paul B. • Lykens , PA • October 10, 2021
I ordered the replacement part and had it reinstalled in 5 minutes. The dishwasher works like new.
Read more
More
$168.95
- Compare At:
-
$201.05
- You Save:
-
$32.10
Genuine Whirlpool part
By: Whirlpool
Part Number: W11661859
Connects the dishwasher sump outlet to the drain hose. Replace if cracked, leaking, or if the internal flapper valve is warped and no longer sealing.
Do-It-Yourself Stories from Customers like You
Fine particle residue left on otherwise clean dishes Aean P. • Berkeley , CA • July 09, 2025
Our dishes were getting mostly clean but we started finding really fine food particles inside cups/bowls (especially our tall travel mugs). Very long story short, the rubber flapper valve in the adapter assembly had warped and was no longer closing, so dirty water was remaining in the tub during the rinse cycle. I may just buy an extra since it will probably fail again in a few years and I'll need to replace it again.
Read more
More
$19.31
- Compare At:
-
$22.98
- You Save:
-
$3.67
Genuine Whirlpool part
By: Whirlpool
Part Number: 3385556
12 Ft in length
Do-It-Yourself Stories from Customers like You
Mice chewed the drain hose and power cord Noah C. • Eastsound , WA • February 16, 2015
Read directions on how to change the power cord and watched video on your site on how to change the drain hose. Everything went perfectly.
Read more
More
$28.43
- Compare At:
-
$33.83
- You Save:
-
$5.40
Genuine Speed Queen part
By: Speed Queen
Part Number: D510213
This sensor monitors operating conditions and relays accurate feedback to the control so cycles run properly. Replacing a failed sensor helps restore correct operation and prevent erratic behavior or fault codes. What it does:
- Detects a specific operating condition and sends a signal to the control
- Helps the machine regulate cycle timing and performance
- Can cause error codes, cycles that won't start or advance, or intermittent shutdowns when failing
- Lead to inconsistent temperatures or sensing behavior depending on application
What's included:
Install notes:
- Disconnect power (and shut off gas/water, if applicable) before servicing
- Access the sensor; note wire positions and connector orientation
- Install the new sensor in the same location and orientation; seat connectors fully
- Clear any stored faults and run a test cycle per the tech sheet
More
$63.61
- Compare At:
-
$75.70
- You Save:
-
$12.09
Genuine Whirlpool part
By: Whirlpool
Part Number: W10844267
Secures and seals your refrigerator's water filter. Replace if cracked, leaking, or filter won't seat properly. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Water leak. James S. • Aurora , IL • November 13, 2023
Changed out the water filter housing.
Read more
More
$103.33
- Compare At:
-
$124.00
- You Save:
-
$20.67
Genuine Ge part
By: Ge
Part Number: WR50X134
Freezer cold but fridge warm? Excessive frost buildup? Your defrost thermostat may have failed. This sensor controls the defrost cycle timing. Easy DIY fix.
More
$46.67
- Compare At:
-
$55.07
- You Save:
-
$8.40