Compressor Start Relay Overload Parts
Genuine Bosch part
By: Bosch
Part Number: 00622858
If your oven won't start or runs with the door open, this door interlock switch detects proper closure and latching. DIY repair in under an hour.
Do-It-Yourself Stories from Customers like You
Broil element had gone bad due to age and use Sherwood O. • Orange , CA • August 22, 2015
This turned out to be a very complicated repair ONLY because the wires that attached to the very far end of the broil element came detached inside and behind the wall of the oven. It is one step this side of impossible to fish the wires out and reconnect them to the new element.
This would be a very easy job PROVIDED that you do not allow the two wires that connect to the element to become detached inside the rear oven wall.
Read more
More
$31.43
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Bosch part
By: Bosch
Part Number: 00624610
This rotary potentiometer converts shaft rotation into an electrical signal the control board can read, providing precise position feedback for user selections. Replace it if inputs become erratic, jump between settings, or the control stops responding.
- Provides rotary position feedback to the electronic control
- Enables accurate selection and adjustment of functions or setpoints
- Wear or damage can cause drifting, dead spots, or incorrect readings
- Intermittent or no response to input is a common failure symptom
What's included: 1 potentiometer Install notes:
- Disconnect power before servicing
- Access the control/console area to reach the component
- Note shaft orientation and any connector positions; transfer exactly to the new part
- Handle electronics with ESD care and verify smooth, full-range operation after reassembly
More
$111.95
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Frigidaire part
By: Frigidaire
Part Number: 241707712
Refrigerator won't cool or compressor won't start? This compressor start relay energizes the start winding to restore cooling. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
Starter Charles S. • Lithonia , GA • November 25, 2019
Replaced starter and compressor run capacitor.
Read more
More
$63.65
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Frigidaire part
By: Frigidaire
Part Number: 316259800
This rocker switch is the on/off control used in the appliance's control panel. It opens and closes the circuit to a selected feature, restoring dependable operation when the original switch becomes worn, stuck, or fails.
- Controls a single on/off circuit from the control panel
- Restores proper switching for the associated feature
- Common symptoms: feature won't turn on or off, light or function flickers or stays on, switch feels loose or sticks
- Replaces a cracked, burned, or unresponsive rocker
What's included: 1 rocker switch Install notes:
- Disconnect power at the breaker before servicing
- Access the switch from the control panel or mounting area; note/photograph wire positions
- Move wires to the new switch one at a time and seat the switch securely in the panel opening
- Restore power and test operation before reassembly
Do-It-Yourself Stories from Customers like You
Convection "speed bake" was not working Amanda Y. • Raymond , WA • June 15, 2019
I ordered the rocker switch to replace and it, fixed the problem.
Read more
More
$26.95
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304454273
This potentiometer kit is the user-adjustment control the appliance reads to set operating levels. Replacing a worn potentiometer restores smooth, predictable response when you turn the knob, helping the control register settings accurately.
- Varies electrical resistance so the control can interpret knob position
- Helps set functions such as speed, power level, or temperature as designed
- Failure can present as no change when turning the knob, jumpy/erratic response, or settings stuck at one level
- Can also cause intermittent operation or "dead spots" while adjusting
What's included: 1 potentiometer kit. Install notes:
- Disconnect power to the appliance before servicing
- Access the control area; note wire positions or take a photo before removal
- Transfer any knob/shaft adapter from the old part if applicable; secure the new pot without over-tightening
- Route wiring away from sharp edges and heat sources; verify proper operation before reassembly
Do-It-Yourself Stories from Customers like You
Broken part. Camille Q. • Sunrise , FL • February 04, 2018
Easy 10 minutes
Read more
More
$83.24
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WB21K10130
Burner won't turn on or heat settings won't change? This control switch sail assembly restores the actuator that engages your range's control switch.
More
$84.69
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WB24K5085
Fixes F1 or F2 error codes and prevents overheating in ovens. This safety switch monitors temperature limits to protect components. Direct fit part.
Do-It-Yourself Stories from Customers like You
It would show a message of f2 after the oven had been on for about 15 20 minutes Elaine M K. • Pottstown , PA • November 09, 2015
We purchased a part called Limit Switch from you. It totally corrected the problem.
Read more
More
$55.22
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WB24X10055
This 3-speed blower switch controls the exhaust fan in your range hood, allowing you to select low, medium, or high airflow. Replacing a worn switch can restore dependable ventilation and proper speed control. What it does:
- Selects low, medium, or high fan speed by routing power to the blower motor
- Helps resolve a fan that will not run, runs only on one speed, or will not change speeds
- Can address a switch that feels loose, sticks, or works intermittently
What's included:
- 1 three-speed blower switch
Install notes:
- Disconnect power at the breaker before servicing
- Access the control area; note wire locations (or take a photo) and transfer wires to the new switch one at a time
- Ensure push-on terminals are fully seated and secure
- Test all fan speeds before reassembly
Also known as: range hood fan switch, blower speed selector
Do-It-Yourself Stories from Customers like You
Switches to fan and bridge burner no longer worked Aaron G. • Benson , NC • April 07, 2017
We ordered the parts and watched the help videos. It was "almost" exact in telling us what we needed to go. Our cooktop is 16 years old and had a ton of greasy buildup that had slowly gotten down into the knobs and was a sticky mess to undo.
However the parts fit perfectly, and after 2 hours of careful "home engineering" we made it happen and everything works aweome now. My dad then decided to dissect the older switches, and proclaimed that we probably could have cleaned the connecters...
Read more
More
$88.56
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Whirlpool part
By: Whirlpool
Part Number: WP4456027
Fix a dual burner that won't heat or lacks proper temperature control. This infinite switch restores heat regulation for accurate simmer-to-boil cooking.
Do-It-Yourself Stories from Customers like You
Burner switch failure James C. • Estes Park , CO • November 30, 2015
Ordered a new switch (4456027) from you. You seemed to have the best price and guaranteed that it was a OEM part -not everybody did. I had repaired Jenn Air cook tops before so I thought this was not a problem. Wrong. Mostly it was my own stupidity. I exchanged the wires from the old switch to the new one at a time but did write down where the original wires went. Flipped the breakers back on. Only one heater got hot. Searched the internet for several days for a wiring diagram. Nothing much....
Read more
More
$83.95
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WR07X10133
Fix a refrigerator that won't cool and clicks every few minutes. This start relay and overload assembly mounts on the compressor to restore reliable starting.
Do-It-Yourself Stories from Customers like You
Refrigerator not cooling and clicking sound every 25 minutes, had same problem on another refrigerator several years back so knew it was the start relay James G. • Huntington Beach , CA • September 06, 2021
Pulled the relay off of the condenser motor (3 pin connection) and removed 2 wire feeds. Reversed the procedure for the install. Ordered the new relay and decided to replace the run capacitor as well just to be safe. Appliance Parts Pros was a really good website to help identify the 2 part numbers and see pictures that confirmed they were the same as the original. Price was competitive with others.
Read more
More
$47.77
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Whirlpool part
By: Whirlpool
Part Number: 12002782
Refrigerator not cooling or making clicking sounds? This compressor relay and overload kit fixes starting issues. DIY repair takes about 30 minutes.
Do-It-Yourself Stories from Customers like You
About 9:30 pm on a friday night two weeks ago i noticed my freezer part in the refrigerator was not holding the cold and ice cream had become liquid! Hemant P. • Arlington , VA • September 12, 2014
I have a Maytag Model PTB1952GRQ Serial Number 11003378AJ Top / Bottom refrigerator. It suddenly stopped working and would no longer be freezing / cooling as a result of a failure of the compressor not starting. I was very upset and went to the web site of appliancepartspros.that had a lot of helpful information available. I also visited many other sites and researched / read and looked at all kinds of information on the we sites. A lot of information was pointing to the fact that the...
Read more
More
$75.95
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Frigidaire part
By: Frigidaire
Part Number: 216954212
This is the start device (relay) that attaches to the compressor and provides the initial electrical boost needed to start the compressor motor. It plays a critical role in the refrigeration cycle by ensuring the compressor starts reliably. Replace this part if the compressor clicks on and off repeatedly, fails to start, or if the refrigerator is not cooling properly.
Do-It-Yourself Stories from Customers like You
Compressor would not start. Gregory H. • Allen City , KY • June 11, 2020
Changed out the controller.
Read more
More
$80.95
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Speed Queen part
By: Speed Queen
Part Number: 35115
This 3-position temperature switch selects the dryer's heat level so the appliance reaches the desired drying temperature. It replaces a worn or faulty selector to restore proper temperature selection and consistent drying performance. What it does:
- Switches between three temperature settings to control dryer heat levels.
- Routes power to the heater circuit based on the selected heat setting.
- Commonly replaces a switch that causes incorrect heat, no heat on some settings, or inability to change temperature.
- Works with the dryer's control system and thermostats to maintain selected drying temperature.
What's included: One temperature switch (3-position). Install notes:
- Disconnect power to the appliance before attempting any service.
- Handle terminals and connectors carefully; match wiring to original locations or take a photo before removal.
- Verify operation with a multimeter for continuity per service manual before and after installation.
More
$26.95
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Whirlpool part
By: Whirlpool
Part Number: W10160407
Refrigerator not cooling or humming without starting? The compressor pumps refrigerant to cool your fridge. Requires EPA certification for install.
More
$406.34
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WB24K10017
Burner won't spark or ignite? This ignition switch controls the spark module for gas range surface burners. Mounts on the valve assembly behind knobs.
Do-It-Yourself Stories from Customers like You
1 burner was not igniting the sparker on a low end 20 year old GE stove. Benjamin F. • Villa Park , IL • January 09, 2022
Rather than replacing the whole ignition switch harness, I cut out the broken switch and replaced it with Burner Ignition Switch WB24K10017 / AP2632529. Wire stripper, small wire nuts, and electrical tape were also used.
At first, the new switch was constantly on when the knob was in the off position. The gas valve shaft has a "U" shape. When the U is right side up, the gas is off and so should the igniter. The gas valve shaft position couldn't be changed, so instead, I re-mounted the...
Read more
More
$51.95
IN STOCK
Most orders arrive by Wednesday, November 25
Genuine Ge part
By: Ge
Part Number: WE4M412
Fix a dryer that won't start or starts intermittently with this start switch replacement. Restores the start circuit for reliable operation. Easy DIY fix.
More
$117.52
IN STOCK
Most orders arrive by Wednesday, November 25