Lower Small Engine Regular Starter Parts

• Won't start

First I have an LG French Door with a bottom freezer. It quit cooling. I went on line and watched some very informative You Tube videos. I trouble shot according to these videos. In these videos it shows that if there is a click coming off the compressor it has too meanings, the compressor is froze or the start relay is bad. I ohmed the compressor and had no open wires in the compressor. I then shook the relay and it was making noise. The videos stated that is there is a noise in the relay... Read more

By reading the forums I first thought it may be the thermostat. I bypassed the thermostat wiring and the dryer still turned off after a few second of running. The second check was for the door switch. I couldn't find an explanation of how to bypass, so I just ordered a new one to try. It worked. Read more

Replaced the Thermistor Assembly and also picked up Overload Protection circuit per the comments posted by the "experts" on the web site. Both parts cheap enough. I ordered parts at 3:30 in the afternoon and they showed up the next morning from half way across the country. Outstanding service. It also fixed the 9 year old refrigerator. Replacing the parts took about a half hour most of which was moving the unit from the wall and removing the panel to get at the parts. Read more

I replaced the part i ordered and it worked great! Read more

I Replaced the power resistor. The old resistor had a small burnt spot and tested infinity for resistance.The terminals were too small so I had to make new connector. Any 5000 ohm ceramic filled resistor would have worked also. Read more

• No heat or not enough heat

GE Gas Dryer Model DBVH512GF1WW began to heat for only a short amount of time so drying clothes took WAY too long. Read online that the first thing to replace are the solenoids. Bought the two solenoids from AppliancePartsPros.com for about $50 total, and it seems to have fixed the problem. Had to watch a few videos to learn to disassemble the dryer, and the job took a couple of hours, but now that I know what I'm doing it could be done in less than 30 minutes. Also, the old solenoids tested... Read more

Replaced the start s/w Read more

After watching repair videos, I decided I could order the parts needed and do it myself for less than a service call, not to mention the additional cost for parts markup and installation that a service technician would charge. I am very pleased that I did. I ordered the start relay, overload and capacitor with some help from Ilya at customer service to make sure I was getting the correct replacements. Installation was easy. The hardest thing was contorting my body into a position where I could... Read more

• Won't start

We isolated a burning smell in our kitchen to our refrigerator, GE Profile PSS23MGTCCC which we purchased in November of 2006. This occurred at 3AM on 29 January 2015 and I am thankful that my wife got me up to investigate this odor. I unplugged the refrigerator. I plugged the refrigerator back in at 6AM thinking it had time to cool. The burning smell happened immediately and I unplugged the refrigerator again right away. My son in-law looked up some possible issues that could have... Read more

Two screws remove the top. Unplug the wires to the old relay, give it a quarter turn and it's out. A five minute procedure. What took five hours was replacing the dryer duct work that I discovered was mostly crushed on its way from the laundry room, through a couple of walls to the exterior. Read more

Check compressor with my Hotwire kit I made when I worked for GE. When removing the compressor relay it broke in pieces. Ordered and replaced new relay, overload & run capacitor. Still did not work. Check if there’s power to compressor and found no voltage. Took control board out and found a component burnt. Ordered and replaced control board. Everything is back to normal. Love your service. Parts was supposed to come in 3-5 days but came next day instead. I am very very impressed and grateful.... Read more

Looked up possible causes on line and found video about trouble shooting. It said to check starter cap and run relay on side of compressor. Removed both and found both were bad .ordered replacements on line from appliancePartspros.com. Installed new parts and is working properly. This repair job was on a 2012 Frigidaire refrig. You would think a refrig. Would last longer than 4 years. The original parts and the replacement parts were light weight and cheaply made. I'll probably be doing this... Read more

Ordered parts arrived in two days. Ten minute fix with one wrench. Should have done it years ago. Read more

I replaced the cycle switch, fixing the lack of heat. The timer switch replacement fixed the auto cool down. I watched a cycle switch replacement on Youtube, demonstrating removal of the top console, which answered the only question I had about the repair. The timer switch was a hundred bucks. The only thing to be said about that is that it was a lot cheaper than a repairman or replacing the dryer. Read more

Purchased a new starter and compressor run capacitor. Unplugged appliance from wall outlet. removed clip that holds these item in place. unplugged starter from compressor and from electrical wiring. plugged capacitor into starter, then plugged the electrical connection into assembly. Plugged starter into compressor. Plugged the appliance into wall outlet and the unit was running again Read more

The ordeal began after wiping around burner knobs with a moist paper towel with cleaner and wrapping the towel around the burner knob shaft to clean around it. The cooktop stopped sparking on all the 5 burners and no red LED light. There was gas flow and I could light the burner using a lighter. I looked up and found a couple of good youtube videos on troubleshooting and also came upon the AppliancePartsPros.com site. I opened the cooktop (youtube video helped) after turning off the gas supply... Read more