Refridge Tape Icemaker Parts
Genuine Frigidaire part
By: Frigidaire
Part Number: 242193212
Replaces worn fresh food door seal to restore airtight closure, prevent condensation, and reduce energy loss. Replace when torn, warped, or gapped.
Do-It-Yourself Stories from Customers like You
I needed to replace the gasket on the fresh food door of the fridgerator Geralyn Z. • Fairfield , NJ • March 15, 2015
It could not have been easier. I simply pulled the old gasket off and pushed the replacement gasket in place until it was secure all around the door. Very easy fix.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: W11768590
Seals the dishwasher door to prevent leaks. Replace if you see water pooling at the door bottom or dripping during cycles. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
Door seal leak. Derek P. • Mount Horeb , WI • December 08, 2017
Put a new door seal in. Super easy and no leaks.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: W10830046
Creates an airtight seal on your refrigerator door to prevent cold air loss and condensation. Replace when cracked, torn, or not sealing properly.
Do-It-Yourself Stories from Customers like You
Needed replacement of both refrigerator section gaskets George M. • Lexington , MA • February 17, 2015
Right-side gasket replacement was straightforward. Left side required removal of mullion, which stumped me. I contacted Appliance Parts Pros who gave me the necessary instructions: Remove the center screw and lift up the mullion. Simple enough, once I knew how to do it.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: W10443320
Seals freezer door to maintain temperature and prevent ice buildup. Replace if doors won't stay shut or ice forms. Confirm fit by model.
Do-It-Yourself Stories from Customers like You
Due to bad door seal ice built up in bottom of freezer water then leaking out Christopher K. • Alexandria , VA • July 19, 2016
Door gasket was easy to remove and reinstall. Original gasket was penetrated while cleaning food stuff from folds in the seal below the frig doors. (Gasket is very fragile so don't try to expand the folds while cleaning. I used my finger and a paper towel but in hindsight should have used a Q-Tip. Also, when installing the new gasket you have to be sure the seam folds over the edge of the door and doesn't get caught underneath.
Read more
More
Genuine Lg part
By: Lg
Part Number: AEQ73110210
Ice maker stopped working or producing misshapen ice? This complete assembly replaces a faulty ice maker. Moderate DIY repair, about 1 hour with basic tools.
Do-It-Yourself Stories from Customers like You
Ice maker quit working. Lee H. • Cleveland , MN • June 04, 2020
This was easier then I made it. Originally took the actual ice maker out without removing the whole system from the door. There are 3 silver screws that do that hold the whole mechanism in place, as opposed to the 5 white screws that hold the ice maker in place. With the entire assembly out it was a matter of routing the ground wire, retaping the wires, and then the whole assembly went back into the door without a problem. Need a phillips and a flat screwdriver, I also found a needle nose...
Read more
More
Genuine Ge part
By: Ge
Part Number: WD8X228
The Tub Corner Baffle is an OEM part for GE dishwashers. This rubber component is placed in the corners of the dishwasher tub to prevent water from leaking out during the wash cycle. It acts as a barrier, directing water back into the tub and ensuring efficient operation. This is the left side. For the right side, use WD8X227.
Causes of a bad part can include prolonged exposure to detergents and hot water, leading to material breakdown, or physical damage from loading and unloading dishes.
Symptoms of a bad Tub Corner Baffle include:
- Visible signs of wear or damage
- Water leakage from the corners of the dishwasher door
- Unusual noises during operation
This OEM GE part can also be used on Hotpoint, RCA, and Kenmore/Sears appliances.
Do-It-Yourself Stories from Customers like You
Water emptied out under the door of my 24 yr old GE dishwasher on to the floor. Andrea B. • Harrisburg , PA • September 22, 2018
After researching on the APP site, I decided what I thought I would need and purchased a new Gasket, Gasket Insert, Left & Right Corner Baffles from APP. The parts were shipped immediately. However, I’m an 80 yr. old female so I procrastinated for almost 6 weeks before deciding to 'tackle' the repair myself rather than hiring an appliance repair person or "handyman".
I went back into the AppliancePartsPros site and reviewed the wonderful videos related to the repair since Matt had made it...
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 241872512
Replace your refrigerator door gasket to restore an airtight seal, prevent warm air entry, and improve cooling efficiency. Easy press-in install.
Do-It-Yourself Stories from Customers like You
Needed new refrigerator door gasket Emmanouel S. • Brooklyn , NY • October 30, 2015
With no problem at all
Read more
More
Genuine Ge part
By: Ge
Part Number: WD8X227
The Tub Corner Baffle is an OEM part for GE dishwashers. It is strategically placed at the corners of the dishwasher tub to prevent water from leaking out during operation. For the left side use WD8X228. Color: Black.
Symptoms of a bad Tub Corner Baffle include:
- Water leaking from the corners of the dishwasher door.
- Pools of water forming near the dishwasher after operation.
- Decreased cleaning performance due to water escaping the wash cycle area.
Causes of a bad tub corner baffle can include wear and tear from regular use, improper installation leading to gaps or looseness, and degradation of the material over time due to exposure to detergents and high temperatures.
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Water emptied out under the door of my 24 yr old GE dishwasher on to the floor. Andrea B. • Harrisburg , PA • September 22, 2018
After researching on the APP site, I decided what I thought I would need and purchased a new Gasket, Gasket Insert, Left & Right Corner Baffles from APP. The parts were shipped immediately. However, I’m an 80 yr. old female so I procrastinated for almost 6 weeks before deciding to 'tackle' the repair myself rather than hiring an appliance repair person or "handyman".
I went back into the AppliancePartsPros site and reviewed the wonderful videos related to the repair since Matt had made it...
Read more
More
Genuine Ge part
By: Ge
Part Number: WR17X11705
Ice won't dispense? A broken auger often causes this. This helical shaft pushes ice from bucket to chute. DIY-friendly repair, about 20 minutes.
This part fixes the following symptoms
-
Ice maker dispenses too little ice
See more...
Do-It-Yourself Stories from Customers like You
Ice bucket auger broke up front where the ice is pushed out of the freezer Mark D. • Columbia , MO • March 25, 2017
This was a little more involved than I originally thought, but after watching the video on the site it wasn't so bad. They walk you through each step verbally and visibly so you can see exactly what to do. Replacing the auger took around 20 minutes, and only that long because the screw holding the ice shield was a bit tough to turn. I just applied gentle pressure and turned slowly until it became loose. The rest was fairly easy, but I did get a small cut from the ice crusher blades. Nothing...
Read more
More
Genuine Ge part
By: Ge
Part Number: WR29X43990
Ice dispenser not working or auger broken? This ice bucket auger moves ice from storage to the dispenser chute. DIY repair in 30-45 minutes with video.
Do-It-Yourself Stories from Customers like You
Broken auger. Guy S. • Corona , CA • March 19, 2017
I watched the video that you provided and the repair went very smoothly. The video was specific to the exact part that I purchased. Great instruction and easy repair!
Read more
More
Genuine Ge part
By: Ge
Part Number: WR29X43994
Ice won't dispense or auger cracked? This refrigerator ice bucket and auger assembly stores and moves ice to your dispenser. Easy DIY replacement.
Do-It-Yourself Stories from Customers like You
Broken auger would not propel ice to dispenser George M. • Birmingham , AL • January 03, 2017
Just bought the whole assembly and slid it in.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WPY055980
The High-Temperature Adhesive Tube is an OEM part for Whirlpool appliances. This adhesive is specifically formulated to withstand extreme temperatures, making it ideal for securing components in ovens, dryers, and other high-heat environments. It is commonly used to seal or repair gaskets, felt seals, and other parts that require a durable bond to maintain integrity under thermal stress.
Symptoms of a need for High-Temperature Adhesive include:
- Loose components or seals within high-heat appliances
- Heat escaping from appliance seals
- Unusual noises due to parts shifting that are normally secured
Causes for the use of high-temperature adhesive can stem from normal wear and tear that loosens components or degradation of previous adhesive applications due to prolonged exposure to high temperatures.
This product is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
This part fixes the following symptoms
-
Marks left on clothes
-
Takes too long to dry
-
Shakes and moves
See more...
Do-It-Yourself Stories from Customers like You
Thermal fuse failure. John O. • Parma , OH • February 14, 2017
After replacing thermal fuse once and having it fail a second time, I had to dig a little deeper to uncover the problem. I checked for blockage in the vent but everything was clear. I did, however, find that the drum had some up and down play in it. After closer inspection, I could see that the front drum seal was actually worn to the point that I could see a gap between the seal and the drum. I figured that the gap in the seal was letting air in and not letting sufficient air flow through the...
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10300024
Ice maker not making ice or leaking water? This complete ice maker assembly fixes frozen, jammed, or non-ejecting ice issues. DIY-friendly replacement.
Do-It-Yourself Stories from Customers like You
Ice maker assembly failed Ronald B. • Fort Myers , FL • January 09, 2026
After ordering the part, I first watched the video several times. Then I placed my phone on my workspace so that I could start and stop the video when following the step-by-step instructions. Then I shut down the refrigerator circuit breaker while I removed the ice container and full ice maker components. I then closed the refrigerator doors to keep the cold air in. I kept starting and stopping the video as I went, as I unplugged wiring components, connection jumpers, the ice maker shutoff...
Read more
More
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304507200
This is the rubber door gasket that seals the freezer door to the cabinet, preventing warm air from entering and cold air from escaping. It attaches along the perimeter of the door and creates an airtight seal when the door is closed. Replace this gasket if you notice frost buildup inside the freezer, the door doesn't seal tightly, the compressor runs constantly, or the gasket is cracked, torn, or warped.
Do-It-Yourself Stories from Customers like You
The seal around the door was not sealing Ron W. • Bakersfield , CA • September 22, 2014
Ordered a new seal, and replaced it with a new one freezer works great now.
Read more
More
Genuine Ge part
By: Ge
Part Number: WR14X36194
Freezer door gasket seals the freezer compartment to maintain temperature. Replace if torn, cracked, or not sealing properly. Confirm fit by model number.
Do-It-Yourself Stories from Customers like You
The seal on the freezer door had to be replaced. Michael C. • Mesquite , NV • October 03, 2022
Emptied the freezer and removed the drawers to allow access to the seal.
Read more
More
Genuine Samsung part
By: Samsung
Part Number: DA97-07603B
Ice maker stopped working or making loud popping sounds? This assembly restores ice production. DIY-friendly repair—just unscrew, unplug, and swap.
This part fixes the following symptoms
-
Ice maker dispenses too much ice
-
Ice maker not making ice
See more...
Do-It-Yourself Stories from Customers like You
Displayed e1 error code the root cause was the sensor (thermistor) that got ripped off of the roof of the freezer Jon S. • Tuscarora , MD • February 21, 2015
Since I could not find the correct thermistor from the schematic provided, I ordered the thermistor harness for the evaporator. I cut the harness and spliced it to the sheared thermistor wires on the roof of the freezer compartment. It now works fine with a little "farmer ingenuity" help. Samsung was absolutely no help at all, but the guy that I spoke with over the phone at APP sure was. This site is now my "go to" for appliance parts! Tip for others with this model. Do not overfill the upper...
Read more
More