Hardware Hand Small Engine Fuel Cap Parts

In order it SHOULD be done: Pried off two white caps covering the screws that attach the flap to the left door, then removed screws. Lifted flap up to remove from door and disconnected cable. Used a thin blade to pry out the inner cover of the flap, then carefully pried out the insulation piece inside. Loosened the screw holding the center cap from the inside and removed cap. Worked the cable out of the hinge piece so it could be removed and cable pulled through case. Pried upper and lower caps... Read more

Was an easy fix with the new part and instructions. Read more

Common theme on the blogs was thermistors and or defrost heater/thermostat. Ran self-diagnostics which turned on defrost heater which was fine. All five thermistors indicated ok on diagnostic also, but I read more than one time "replace the thermistors no matter what if your FF section isn't cooling". So I ordered all five thermistors and defrost limiter thermostat. Received all in 48 hours (great shipping service), took me about three hours to replace all thermistors and thermostat just as... Read more

Ordered all the parts I needed to finish off a Craigslist purchase that had some cosmetic and function items missing. Thanks for all the parts at great prices! Read more

I was able to order a new ice dispenser crusher cover and cover bucket dispenser and easily took off the broken ones and attached the new ones, and it works great again! Read more

All of the information on the web repair sites said "replace the hinges as the springs are worn out." Didn't fix the problem. The top of the door still wouldn't seal, and the. Leaning latch wouldn't catch the door unless you pressed on the door. The inside panel of the door was fatigued. Too many turkeys were set on the door over the years. The hinges are attached to that inside panel, so the stress points were bent over time. I replaced the inside steel panel. Took about an hour. Was able... Read more

• Will not dispense detergent

I ordered a new vario motor and a soap dispenser. I turned off the water and the breaker, disconnected the water line and the power at the front base of the unit, disconnected the drain hose from the garbage dispenser, and pulled out the dishwasher and laid it on a blanket on its face. I unscrewed and removed the plainly visible vario motor on the bottom of the machine and removed the cam from the shaft. I then used a needle nose plier to carefully turn the D-shaft on the new motor to exactly... Read more

I ordered the mounting bracket, mounting hardware and template for the top cabinet. Everything I ordered was an exact fit. Install only took about 30 minutes after running the new electrical for the microwave. Appliance parts helped me save almost $400. Read more

Replaced door Read more

Replaced the glass Read more

Replacing the trim takes a little bit of alignment and light force. The trim slides over the glass panel of the door, with the glass sliding into plastic tabs. We kept the door nearly vertical (almost closed), lined up the tabs on the trim with the glass door, and used mild force to slide the trim down onto the glass door. (Also, we found that the tabs on trim we ordered were much bigger than the tabs on our broken trim. This is probably due to slight variations in Frigidaire's design over... Read more

Was able to diagnose problem at AppliancePartsPros.com by entering the model #. This is apparently a common problem with this Refrigerator Replaced Light Socket Assembly, Lamp Reflector, Lamp Case and Lamp Cover. Also replaced the main circuit board (not sure if this was necessary). The wiring on the Light Socket Assembly was different than the original, so it was a bit confusing how to assemble it, and no screws were provided to attach it to the Lamp Reflector - figuring this out took most... Read more

I drilled old lock out and installed new lock box. This was the info your Tech had given me and as always your Techs are on top of all situations. This took about 15 minutes and it's back collecting money. Thanks for such quick and reliable service. The tracking info was a big help , keeping GM advised as to final repair , knowing when part would arrive. I again want to thank you for your reliable service and keeping me aware of where my part was and when I can install. Read more