Control Board Parts

REPLACED THE USER INTERFACE BOARD. WORKS FINE NOW!! Read more

• Won't start

Tried to put refrigerator in defrost mode and defrost would not initiate. Checked the bi-metal and heater, both tested good. Replaced the ADC board and refrigerator went in to defrost. problem solved. Read more

I could not find specific online instructions for this job. Here are some tips. 1. Unplug the washer. 2. Unscrew the dial on the broken timer. 3. Gently pry up the thin plastic place-indicator plate (the thing with the arrow under the dial) with two flathead screwdrivers. 4. Unscrew the two hex screws holding the old timer in place. 5. Unscrew the phillips-head screws holding the console in place and flip up the console. 6. Remove the electrical connector from the bad timer, and remove the bad... Read more

Replaced the board and put it back together. Read more

There was no power coming out of the control board to the igniter so I replaced the board and walay it work and all is good in the kitchen Read more

• Freezer section too warm
• Fridge too warm

Replaced the heater, timer, and wiring harness Read more

I diagnosed the problem, identified faulty parts, and replaced those components. Read more

Ordered part from appliance parts pro,replaced and dryer is drying again Read more

• Little to no heat when broiling

We ordered the Pwb(pcb) Assembly,sub, Part Number 6871W1N012B & received the part the next day. I couldn't believe how fast. My husband was able to replace in 15 minutes. My oven worked again! Read more

I replaced the defrost thermostat and the defrost timer. That corrected the problem. Be careful when ordering your parts. I put in my model# and they gave me a defrost timer that was incorrect. I had to return at my cost and order the correct one. Don't assume because you put in your model# that the part is correct. On each part there is a box to put in your model# to check to see if it fits your model. Don't assume that because you put your model# in before that it fits. If not sure, call them... Read more

• Won't start

I purchased a new igniter for the bake assembly and found that it, unfortunately, did not resolve my problem. I measured the resistance of the different points on the gas valve and it was reading within spec so I then purchased this spark module and it did the trick. My gas range is a Kitchenaid kgsk901sss02. I had a LOT of trouble finding where the spark module is located, and eventually found a schematic that shows it's location behind the front control panel of the oven. Upon taking the... Read more

Replaced the Main Control Board Assembly along with the evaporator and condenser fan motors. I thoroughly cleaned the very very dirty condenser with a 4$ brush offered by the parts specialist and while I was at it, I changed the door seals and replaced one of the door trays. Beats the crap out of spending $10,000 on a new refrigerator that because of Covid 19 wouldn't be here before the middle of November. Thank you Matt for your help! Read more

Replaced control module. Read more

• Timer will not advance

Based on an internet search, the likely problem seemed to be a bad timer-control switch because it would hum and click but not advance on a 17-year old washer. Repairman diagnosed the problem as a bad lid-switch-assembly and replaced it - problem solved. Now I need to return the Timer-Control. AppliancePartsPros was very quick to ship the Timer-Control and have a great return policy for an unneeded part. Read more