Etlchmxkq00 Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

• Freezer section too warm
• Noisy

My refrigerator's cooling fan was making a noise. It wasn't loud; in fact, it was barely discernible. However, it was just loud enough to annoy me. The fan blade was hitting the shroud every now and then, creating a subtle, yet annoying sound. I'd tried tightening all the screws back there, and it helped-for a while. The noise came back. After looking at the fan motor, I noticed the bushings; it occurred to me that they might be the culprit. And why not? They were the originals installed at the... Read more

We replaced the main circuit board and the LED started to work and the condenser fan worked, but all we had were relay clicking sounds, but no cooling. The compressor had become so hot trying to work when the main circuit board was amiss, that it had popped the over temperature sensor on its side. As some one point out, if you remove the PTC+OLP assembly with the capacitor on it, and shake it, you will hear a rattle inside---and that is bad. We ordered a second round of parts from... Read more

I ordered a new switch from APP and fixed my fridge. However, the video posted for this repair on this site is not applicable to newer refrigerator models. I have a 2015 GE GTE18IHCRSS and had to drop the control housing (#432 in the diagram) to attach the wire/plug assembly to the switch. Only had to remove the front screw with a 1/4" nut driver and that provided enough of a gap for me to plug in the switch. So the correct method to replace the light switch in a newer model refrigerator is as... Read more

• Freezer not defrosting
• Leaking
• Freezer section too warm
• Fridge too warm

We just had the Defrost Timer replaced less than 90 days ago. Called the appliance company who came to diagnose ($109) and it was the same part, (a $34 part). The part was warrantied, but not the service, which was $270. I saw them install the part in July... less than 5 minutes! The company told me that they bill not by time spent on labor, but according to the "national average" for that repair. They wouldn't give me the warrantied new part without doing the labor. I checked with... Read more

Ordered the proper parts with the help of appliance parts pros very quick shipment and fair pricing and the job is done. Thank you Read more

• Fridge too warm

Replacement of the evaporator fan motor, fan blade, and grommets. The amount of disassembly to reach the part took most of the effort Read more

Replaced defrost heater, temperature and defrost limiter thermostat. After taking the cover off the air chiller I found the coils frozen solid and defrosted it with a hair dryer. Once defrosted I remover the heater coil to test it it was fine, then I could see the defrost limiter was broken and as I put the unit back together I broke the heater tube (it is glass) so I ordered all the parts that might be defective and replaced them for less than the charge of having some one come to check it out. Read more

Put in new one Read more

• Noisy

I had found that the fan in the freezer was making a lot of noise. Turns out the shaft was loose, causing the flan blade to wobble. Replaced the motor and fan and now it runs like a new unit. Read more

• Noisy

After a lot of research on internet we thought it might be the condenser fan motor . we were a but confused as frig still working and cooling. I had imagined if motor gone bad it would just stop . However on taking back off frig we could see fan sometimes slowed and then began loud "animal " squeaking noise ! Although the back bottom of our fridge was relatively open it was very tricky to ease out fan and motor. Fortunately I had also ordered fan and grommet as fan was almost impossible to... Read more

Installed freezer gasket. Read more

Took about 5 min to replace the handle with the parts ordered. Thank you for the fast service. Read more

New Door Handle and the plastic spacers Read more

• Freezer section too warm

1. Unplug the power, 2. Removed the shelving and Ice maker including power cord, 3. Removed the air flow conduits, 4. Removed the back panel, 5. Removed evaporator fan housing and drop down then un clip power supply and remove evaporator fan housing and all and set on a flat surface, 6. Remove the upper bracket holding in evaporator and remove evaporator fan ( be sure to remove the fan blade you'll need it for the new motor ) 7. Popped out the old grommets ( I replaced both since I was there )... Read more

Well at first I thought the defroster element was the problem,so I was removing it to ohm it out and it broke upon removal.After replacing the element I was hoping that was the problem...After a week or so started having same problem with evap. freezing over.So I came back to your site to research what else could be the problem,and low and behold found an article about the defroster thermostat and a video on how to replace it.Ordered the thermostat and it was here within 2 days,replaced the... Read more