Norge Object Stack Blower Wheel Parts

• Spins slowly
• Pumps but will not spin
• Will not agitate

My Maytag washer make a loud screech when the washer tub needed to be stopped by the brake. Last year, I had replaced the suspension springs, the snubber ring, the drive belt and the drain pump. Those repairs worked fine, but a few weeks later, the screeching noise started. So I figured it was the brake system. I thought it would be better to replace the brake rotor and stator together as a set since I was going to disassemble both and they were 18 years old anyway. I decided to replace the... Read more

I removed the front panel of the dryer and the metal cover over the blower wheel. Removed the lock ring and clamp. Removed the old wheel and placed the new wheel on the shaft. I thoroughly cleaned all the lint around the area and inside the front cover. I resealed the metal cover over the blower and reinstalled the front cover. Dryer works great. Easy fix, I spent more time thoroughly cleaning all the lint. Read more

• Noisy

I pulled the refrigerator out, removed the back panel, disconnected the fan motor. I did not know how hard or easy it would be to remove the fan from the motor shaft so I removed the motor with the fan attached and then removed and replaced the fan. This would not be necessary if you have a lot of strength, but if you need leverage to push the fan down on the shaft you might want to disconnect and remove the motor fan assembly too. After replacing the motor assembly and reconnecting I tested by... Read more

Got the make and model. Put it in your web site order form and watched the video. The part came the replacement part was made and job done. Thanks. Great parts, fast shipment and again job done. Read more

Acualy sounded and looked major but with a littel help with you tube the job only took 30 minutes. 3 bolts for the water pump pulley broken pulley poped off new one klick into place simple belt install good to go. Parts saved me $40 and where here in only 2 days. I couldnt be happyer. Read more

Blower wheel and clamp replacement. Initially, we replaced both the belt and drum roller wheels but that did not stop the noise. By reviewing videos on YouTube and AppliancePartsPros, we suspected that the blower wheel could be problematic, even though with front panel of dryer off, we did not see any visual clues to support that theory. Purchased the replacement clamp as well, just for good measure (and it was inexpensive). Note: we did call AppliancePartsPros with our model AND serial numbers... Read more

Decided to order the kit with both rollers even thou the right one looked OK.Also ordered the pulley for the idler. Watched the video for the pulley installation,super helpful on a couple of the steps!! Everything went great. A 14 year old dryer still has life! Parts ordering and delivery was also great!!! Thank you. Read more

Un plugged dryer. It was an easy fix, popped the top up. Removed the two screw that held the front on and also unclipped the door switch. Released tension that was on belt and removed drum. Removed old front slides cleaned up area and replaced them. Popped the ring that held the rear drum wheels and placed the new ones with a dab of grease. Un hooked tension spring for idler and removed old one and put the new one in. Make sure you place it through the correct hole and it makes it firmly into... Read more

Replaced left hand rack adjuster. Read more

Replaced the roller and shaft. The roller had worn 1/4 of the way through the support shaft. Read more