Sb-1042 Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

Took the stove apart*, saw where the mouse had made a nest. It was kind of like a hotel room after a rock star had used it. It was nasty, is what I'm saying. I removed the insulation, which immediately went into a garbage bag and was placed outside, whereupon I took off and nuked the site from orbit. It was the only way to be sure (actually it was disposed of in the proper manner, no nukes were detonated in the course of this repair). Anyway, I ordered the insulation from this site, which was... Read more

• Little to no heat when broiling
• Little to no heat when baking
• Gas igniter glows, but will not light
• Won't start

Replaced the igniter, Simple but there are several points to remember. TURN THE POWER OFF 1) remove the oven door or you will have a hard time reaching the back of the oven. Mine just lifted off. 2) The igniter tip is fragile put a drop cloth over the oven floor in case you drop it even after it is in its holder. 3) The drop cloth will catch screws too if you drop them so they won't fall into the oven. 4) The cable from the oven is very short even after pulling it out from the hole at the back.... Read more

After several attempts at Local Hardware stores and Lowe's and Home Depot to find them I called AppiancePartsPros.com. I gave them the model number and what I was looking for and customer service directed me to the part on the Web site. They were extremely helpful and it was very fast and I got the parts the next day. Read more

I undid the top with a putty knife, took out two screws and took off the front. I replaced the drum rollers and put the new belt on the drum, looped the belt on the idler and then onto the motor pulley. I also put on two new top hold down clips as the old ones broke because they were plastic, the new ones were metal. I took off the back panel and replaced the heating element. The hardest part was cleaning up all of the lint and dirt that had accumulated over the years. It was not difficult,... Read more

• Won't start
• Gas igniter glows, but will not light
• Little to no heat when baking

Replaced the oven igniter, following the general instructions on the ApplicancePartsPro.com website. It took me a little while to figure out how to get to the wiring for the igniter, as I had no access panel on the back to get to the wires. In my particular Whirlpool oven (very old model) it turned out that you have to remove the pots/pans drawer under the oven to get to the exposed wiring at the back. Once I figured this out, the rest of the replacement was a snap. Read more

Perfect...........Easy to find part (picture), Next day delivery ( not expected) Installed clip ( two minutes) All is well! Thanks much. Read more

Have a good old Caloric stove/oven but the horizontal design left the knobs open to grease and water dripping downward into the control knobs. This fouled up the sparking of the oven and one burner on stove. also the front 2 deteriorated burners were allowing some flames to pass under the stovetop. However, as is often the case with the older models(like my 1991 Audi 100), if you can find the parts they can be fixed with one replaced here and there. APP fulfilled my order with excellent... Read more